GE GSHS9NGYSS Use and Care Manual - Page 30
Problem, Possible Causes, What To Do, Lock Controls
UPC - 084691188476
View all GE GSHS9NGYSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Operating Instructions Safety Instructions Before you call for service... Troubleshooting Tips Installation Instructions Problem Ice cubes have odor/taste Small or hollow cubes Slow ice cube freezing Orange glow in the freezer Cube dispenser does not work (on some models) Water has poor taste/ odor (on some models) Water in first glass is warm (on some models) Water dispenser does not work (on some models) Water spurting from dispenser (on some models) Water is not dispensed (on some models) but icemaker is working 30 Possible Causes Ice storage bin needs cleaning. Food transmitting odor/taste to ice cubes. Interior of refrigerator needs cleaning. Water filter clogged. Door left open. Temperature control not set cold enough. Defrost heater is on. What To Do • Empty and wash bin. Discard old cubes. • Wrap foods well. • See Care and cleaning. • Replace filter cartridge with new cartridge or with plug. • Check to see if package is holding door open. • See About the controls. • This is normal. Icemaker turned off or water supply turned off. Ice cubes are frozen to icemaker feeler arm. An item is blocking or has fallen into the ice chute inside the top door bin of the freezer. Irregular ice clumps in storage container. • Turn on icemaker or water supply. • Remove cubes. • Remove any item that might be blocking, or has fallen into, the chute. • Break up with fingertip pressure and discard remaining clumps. • Freezer may be too warm. Adjust the freezer control to a colder setting, one position at a time, until clumps do not form. Dispenser is LOCKED. • Press and hold the Lock Controls pad for 3 seconds. Water dispenser has not been used for a long time. • Dispense water until all water in system is replenished. Normal when refrigerator is first installed. • Wait 24 hours for the refrigerator to completely cool down. Water dispenser has not been used for a long time. • Dispense water until all water in system is replenished. Water system has been drained. • Allow several hours for replenished supply to chill. Water supply line turned off or not connected. Water filter clogged. Air may be trapped in the water system. • See Installing the water line. • Replace filter cartridge or remove filter and install plug. • Press the dispenser arm for at least two minutes. Dispenser is LOCKED. • Press and hold the Lock Controls pad for 3 seconds. Newly-installed filter cartridge. • Run water from the dispenser for 3 minutes (about one and a half gallons). Water in reservoir is frozen. • Call for service. Refrigerator control setting is too cold. • Set to a warmer setting. Consumer Support Troubleshooting Tips