GE GTJ18CBDSA Use and Care Manual - Page 7
About storage drawer and cover removal., About the automatic icemaker.
View all GE GTJ18CBDSA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
About storage drawer and cover removal. GEAppliances.com Not all features are on all models. Adjustable Humidity Drawer (on some models) Slide the control all the way to the HIGH setting to provide high humidity recommended for most vegetables. Slide the control all the way to the LOW setting to provide lower humidity levels recommended for most fruits. Drawer and Cover Removal Drawers can be removed easily by grasping the sides and lifting up slightly while pulling drawers past the stop location. Full-Width Drawer with Plastic Cover To remove the cover, lift it off its supports, pull it forward, tilt it and take it out. Twin Drawer Shelf To remove: 1 Remove the drawers. 2 Reach in, push the front of glass cover up, and at the same time, pull it forward as far as it will come. Tilt it and take it out. Avoid cleaning the cold glass cover with hot water because the extreme temperature difference may cause it to break. 3 Remove the drawer frame. (Always remove the glass cover before you take out the drawer frame.) Lift the frame off the supports at each side and back, pull it forward, tilt it and take it out. To replace: 1 Lower the frame until it rests on the supports at each side and back. 2 Replace the glass cover, pushing its rear edge firmly into the rear frame channel and gently lowering the front into place. 3 Replace the drawers. About the automatic icemaker. A newly-installed refrigerator may take 12 to 24 hours to begin making ice. There are 2 types of icemakers: Icemaker ON OFF Feeler Arm Power Switch Power switch model Automatic Icemaker (on some models) The icemaker will produce approximately 70-100 cubes in a 24-hour period, depending on the freezer compartment temperature, room temperature, number of door openings and other use conditions. If the refrigerator is operated before the water connection is made to the icemaker, set the switch to OFF or move the feeler arm to the STOP (up) position. When the refrigerator has been connected to the water supply, set the switch to the ON position or move the feeler arm to the ON (down) position. The icemaker will fill with water when it cools to 15°F. A newly-installed refrigerator may take 12 to 24 hours to begin making ice cubes. When the bin fills to the level of the feeler arm, the icemaker will stop producing ice. It is normal for several cubes to be joined together. If ice is not used frequently, old ice cubes will become cloudy, taste stale, shrink or fuse together. Icemaker Accessory Kit If your refrigerator did not already come equipped with an automatic icemaker, an icemaker accessory kit is available at extra cost. Check the back of the refrigerator for the specific icemaker kit needed for your model. Once the icemaker starts to make ice, it may take up to 48 hours to fill the bin, depending on the temperature settings and number of Feeler Arm in the STOP Feeler Arm in (up) position door openings. You will hear a buzzing sound each time the icemaker fills with water. the ON (down) position Throw away the first few batches of ice to allow the water line to clear. Feeler arm model Be sure nothing interferes with the sweep of 7 the feeler arm.