GE GTS22KBPWW Use and Care Manual - Page 13
Installation Instructions, Preparing to Install the Refrigerator, Refrigerator - canada
UPC - 084691077954
View all GE GTS22KBPWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Installation Instructions Refrigerator Models 22 and 25 Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com In Canada, call 1.800.361.3400 or Visit our Website at: www.geappliances.ca BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT - Save these instructions for local inspector's use. • IMPORTANT - Observe all governing codes and ordinances. • Note to Installer - Be sure to leave these instructions with the Consumer. • Note to Consumer - Keep these instructions for future reference. • Skill level - Installation of this appliance requires basic mechanical skills. • Completion time - Refrigerator Installation 15 minutes • Proper installation is the responsibility of the installer. • Product failure due to improper installation is not covered under the Warranty. WATER SUPPLY TO THE ICEMAKER (ON SOME MODELS) If the refrigerator has an icemaker, it will have to be connected to a cold water line. A GE water supply kit (containing tubing, shutoff valve, fittings and instructions) is available at extra cost from your dealer, by visiting our Website at ge.com (in Canada at www.geappliances.ca) or from Parts and Accessories, 800.626.2002 (in Canada 1.888.261.3055). REFRIGERATOR LOCATION • Do not install the refrigerator where the temperature will go below 60°F (16°C) because it will not run often enough to maintain proper temperatures. • Do not install the refrigerator where the temperature will go above 100°F (37°C) because it will not perform properly. • Install it on a floor strong enough to support it fully loaded. CLEARANCES Allow the following clearances for ease of installation, proper air circulation and plumbing and electrical connections: • Sides 1/8″ (4 mm) • Top 1″ (25 mm) • Back 1″ (25 mm) If the refrigerator is against a wall on either side, allow a 1/8″ (3 mm) door clearance. ROLLERS The rollers have 3 purposes: I Rollers adjust so the doors close on their own when opened about 45°. I Rollers adjust so the refrigerator is firmly positioned on the floor and does not wobble. I Rollers allow you to move the refrigerator away from the wall for cleaning. To adjust the rollers: Remove the base grille by positioning hands as shown. Rotate the bottom of the grille outward until the clips snap out. Pull the grille away from the refrigerator. Using a screwdriver, turn the two front roller adjusting screws clockwise to raise the refrigerator, counterclockwise to lower it. Replace the grille so the notch in the grille will fit around the bottom door hinge. Tilt the top of the grille toward the refrigerator and insert the long metal clips into the top of the oval openings at the bottom of the refrigerator. Rotate the bottom of the grille toward the refrigerator until it snaps into place. 13