GE JB450RFSS Use and Care Manual - Page 24

Lift-Off Oven Door, Oven Heating Elements, Oven Racks, Storage Drawer Removal

Page 24 highlights

Care and cleaning of the range. Pull hinge locks up to unlock Removal position Lift-Off Oven Door The door is very heavy. Be careful when removing and lifting the door. Do not lift door by the handle. WARNING If improperly removed, oven door hinges may suddenly open and can cause personal injury to appendages near the hinge. Follow instructions below to avoid a risk of injury when removing and re-installing the oven door. To remove the door: Fully open the oven door. On each hinge, slide the hinge lock up, making sure it snaps into its fully raised position. Firmly grasp both sides of the door at near the top. Close door until the top of the door is approximately 3" from the range frame. Lift door up and away from the range until both hinge arms are clear of the slots in the range frame. To replace the door: Firmly grasp both sides of the door near the top. With the door at the same angle as the removal position, rest the notch in the bottom of the left hinge arm on the bottom edge of the Notch left hinge slot. The notch in the hinge arm must be fully seated onto the bottom of the slot. Repeat for the right side. Fully open the door. If the door will not fully open, the notches in the bottoms of the hinge arms are not seated correctly onto the bottom edge of the slot. Lift the door off the range and repeat Step 2. Push the hinge locks down to the locked position Close the oven door. Push hinge locks down to lock Oven Racks All oven racks may be cleaned by hand with an abrasive cleaner or steel wool. After cleaning, rinse the racks with clean water and dry with a clean cloth. Gray porcelain-coated oven racks may remain in the oven during the selfcleaning cycle without being damaged. The shiny, silver-colored oven racks may remain in the oven during the self-cleaning cycle, but they will lose their luster and become hard to slide. It will be necessary to grease all oven rack side edges with a light coating of vegetable oil after cleaning them by hand or in the oven. This will help maintain the ease of sliding the racks in and out of the oven. Rail Stop guide Storage Drawer Removal To remove the drawer: Pull the drawer out until it stops. Lift the front of the drawer until the stops clear the guides. Remove the drawer. To replace the drawer: Place the drawer rails on the guides. Push the drawer back until it stops. Lift the front of the drawer and push back until the stops clear the guides. Lower the front of the drawer and push back until it closes. Oven Heating Elements Do not clean the bake element or the broil element. Any soil will burn off when the elements are heated. To clean the oven floor, gently lift the bake element. On some models, the bake element is not exposed and is under the oven floor. Clean with warm, soapy water. 24

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36

24
Care and cleaning of the range.
Lift-Off Oven Door
The door is very heavy. Be careful when
removing and lifting the door. Do not lift door
by the handle.
If improperly
removed, oven
door hinges may suddenly open and can
cause personal injury to appendages near
the hinge. Follow instructions below to
avoid a risk of injury when removing and
re-installing the oven door.
To remove the door:
Fully open the oven door.
On each hinge, slide the hinge lock up,
making sure it snaps into its fully raised
position.
Firmly grasp both sides of the door at near
the top.
Close door until the top of the door is
approximately 3” from the range frame.
Lift door up and away from the range until
both hinge arms are clear of the slots in
the range frame.
To replace the door:
Firmly grasp both sides of the door near
the top.
With the door at the
same angle as the
removal position, rest
the notch in the
bottom of the left
hinge arm on the
bottom edge of the
left hinge slot. The notch in the hinge arm
must be fully seated onto the bottom of
the slot. Repeat for the right side.
Fully open the door. If the door will not fully
open, the notches in the bottoms of the
hinge arms are not seated correctly onto
the bottom edge of the slot. Lift the door
off the range and repeat Step 2.
Push the hinge
locks down to
the locked
position
Close the oven
door.
Removal position
Oven Heating Elements
Do not clean the bake element or the broil
element. Any soil will burn off when the
elements are heated.
To clean the oven floor, gently lift the bake
element.
On some models, the bake element is
not exposed and is under the oven floor. Clean
with warm, soapy water.
Oven Racks
All oven racks may be cleaned by hand with an
abrasive cleaner or steel wool. After cleaning,
rinse the racks with clean water and dry with
a clean cloth. Gray porcelain-coated oven
racks may remain in the oven during the self-
cleaning cycle without being damaged. The
shiny, silver-colored oven racks may remain in
the oven during the self-cleaning cycle, but they
will lose their luster and become hard to slide.
It will be necessary to grease all oven rack side
edges with a light coating of vegetable oil after
cleaning them by hand or in the oven. This will
help maintain the ease of sliding the racks in
and out of the oven.
Storage Drawer Removal
To remove the drawer:
Pull the drawer out until it stops.
Lift the front of the drawer until the stops
clear the guides.
Remove the drawer.
To replace the drawer:
Place the drawer rails on the guides.
Push the drawer back until it stops.
Lift the front of the drawer and push back
until the stops clear the guides.
Lower the front of the drawer and push
back until it closes.
Stop guide
Rail
Pull hinge locks up to unlock
Push hinge locks down to lock
Notch
WARNING