GE JB645RKSS Use and Care Manual - Page 28

Broil Hi/Lo

Get GE JB645RKSS PDF manuals and user guides View all GE JB645RKSS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

TROUBLESHOOTING TIPS Troubleshooting tips (Cont.) ... Before you call for service Problem Sometimes the oven takes longer to preheat to the same temperature Possible Cause Cookware or food in oven. Number of racks in oven. Different cooking modes. Display flashes Unable to get the display to show "SF" Control signals after entering cooking time or start time Oven racks are difficult to slide Drawer does not slide smoothly or drags Steam from the vent Water remaining on oven floor after Steam Clean cycle Oven will not steam clean Power failure. Oven control pads were not touched properly. You forgot to enter a bake temperature or cleaning time. The shiny, silver-colored racks were cleaned in a selfclean cycle. The drawer is out of alignment. Drawer is over-loaded or load is unbalanced. When using the ovens, it is normal to see steam coming out of the oven vents. As the number of racks or amount of food being cooked increases, the amount of visible steam will increase. This is normal. Display flashes HOT. Oven controls improperly set. Oven door is not closed. What To Do The cookware or food in the oven will cause the oven to take longer to preheat. Remove items to reduce preheat time. Adding more racks to the oven will cause the oven to take longer to preheat. Remove some racks. The different cooking modes use different preheat methods to heat the oven for the specific cooking mode. Some modes will take longer than others (i.e. convection bake). Reset the clock. The Broil Hi/Lo and Bake pads must be touched at the same time and held for 3 seconds. Touch the Bake pad and desired temperature or the Self Clean pad and desired clean time. Apply a small amount of vegetable oil to a paper towel and wipe the edges of the oven racks with the paper towel. Do not spray with Pam® or other lubricant sprays. Fully extend the drawer and push it all the way in See the Care and cleaning of the range section. Reduce weight. Redistribute drawer contents. This is normal. Remove any remaining water with a dry cloth or sponge. Allow the oven to cool to room temperature and reset the controls. See the Using Steam Clean section. Make sure you close the door to start steam clean cycle. 28 49-80689-6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
28
49-80689-6
Troubleshooting tips (Cont.) ...
Before you call for service
TROUBLESHOOTING TIPS
Problem
Possible Cause
What To Do
Sometimes the oven
takes longer to preheat
to the same temperature
Cookware or food in oven.
The cookware or food in the oven will cause the oven to take
longer to preheat. Remove items to reduce preheat time.
Number of racks in oven.
Adding more racks to the oven will cause the oven to take
longer to preheat. Remove some racks.
Different cooking modes.
The different cooking modes use different preheat methods
to heat the oven for the specific cooking mode. Some modes
will take longer than others (i.e. convection bake).
Display flashes
Power failure.
Reset the clock.
Unable to get the display
to show “SF”
Oven control pads were not
touched properly.
The
Broil Hi/Lo
and
Bake
pads must be touched at the
same time and held for 3 seconds.
Control signals after
entering cooking time or
start time
You forgot to enter a bake
temperature or cleaning time.
Touch the
Bake
pad and desired temperature or the
Self
Clean
pad and desired clean time.
Oven racks are difficult
to slide
The shiny, silver-colored
racks were cleaned in a self-
clean cycle.
Apply a small amount of vegetable oil to a paper towel and
wipe the edges of the oven racks with the paper towel. Do
not spray with Pam
®
or other lubricant sprays.
Drawer does not slide
smoothly or drags
The drawer is out of
alignment.
Fully extend the drawer and push it all the way in See the
Care and cleaning of the range section.
Drawer is over-loaded or load
is unbalanced.
Reduce weight. Redistribute drawer contents.
Steam from the vent
When using the ovens, it is
normal to see steam coming
out of the oven vents. As the
number of racks or amount of
food being cooked increases,
the amount of visible steam
will increase.
This is normal.
Water remaining on
oven floor after Steam
Clean cycle
This is normal.
Remove any remaining water with a dry cloth or sponge.
Oven will not steam
clean
Display flashes HOT.
Allow the oven to cool to room temperature and reset the
controls.
Oven controls improperly set.
See the Using Steam Clean section.
Oven door is not closed.
Make sure you close the door to start steam clean cycle.