GE JB700DNWW Quick Specs - Page 1

JB700DN GE® 30" Free-Standing Electric Range 30_install_fse_ge.eps Dimensions and Installation Information (in inches) KW Rating 240V 12.0 208V 9.0 Breaker Size 40 Amps† †Note: Check local codes for required breaker size. Effective January 1, 1996, the National Electrical Code requires that new construction (not existing) utilize a 4-conductor connection to an electric range. Receptacle Locations: Locally approved flexible service cord or conduit must be used because terminals are not accessible after range installation. See shaded area in drawing for location of electrical outlet box. Recommended outlet locations allow range to be installed directly against wall. Note: 30" ranges conform to U.L. requirements for 0" spacing from adjacent walls below countertops. To reduce possibility of scorching walls, engineering recommends a minimum of 1-1/2" spacing to allow for possible extended, high-heat, no-load heating element operation. Installation information: Before installing, consult installation instructions packed with product for current dimensional data. For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000. 2-1/2 30-7/8" 30_install_fse_ge.eps All 30" GE gas and electric range backguards are 30-7/8" wide.* Note: 30" ranges conform to U.L. requirements Acceptable electrical outlet area for 0" spacing from ­adjacent walls below countertops. To reduce possible scorching of walls, ­engineering ­recommends a minimum of 30 2-1/2 1-1/2" spacing to allow for possible extended, high heat, no-load heating element operation. 25 *Except these models: JGBS07, JGBS04, JGBPA9c0,ceptable electrical all GE Profile free-standing electric and gas outlet area ranges Fits most countertop backsplash applications. 29-7/8 Consult Use & Care Manual for detailed installation instructions. 46-7/8 30 25 2-1/2 2-1/2 7-1/2 Dimension from wall to front of closed oven door handle is 27-3/4 29-7/8 25-3/8 46-7/8 47-5/8 7-1/2 Dimension from wall to front of closed oven door handle is 27-3/4. 25-3/8 47-5/8 All GE ranges are equipped with an Anti-Tip device. The installation of this device is an important, required step in the installation of the range. Listed by Underwriters Laboratories Specification Revised 10/08 321515