GE JCBP66SPSS Owners Manual - Page 15

Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support Using the clock and timer. Not all features are on all models. To Set the Clock The clock must be set to the correct time of day for the automatic oven timing functions to work properly. The time of day cannot be changed during a delayed cooking or a delayed self-cleaning cycle. Touch the CLOCK pad twice. Touch the + or - pads. Make sure the clock is set to the correct time of day. If the + or - pads are not touched within one minute after you touch the CLOCK pad, the display reverts to the original www.GEAppliances.ca setting. If this happens, touch the CLOCK pad twice and reenter the time of day. Touch the START/ON pad until the time of day shows in the display. This enters the time and starts the clock. To check the time of day when the display is showing other information, simply touch the CLOCK pad. The time of day shows until another pad is touched. The OFF pad does not affect the timer. To Turn Off the Clock Display If you have several clocks in your kitchen, you may wish to turn off the time of day clock display on your range. Touch the CLOCK pad once to turn off the time of day display. Although you will not be able to see it, the clock maintains the correct time of day. Touch the CLOCK pad twice to recall the clock display. To Set the Timer The timer does not control oven operations. The maximum setting on the timer is 9 hours and 59 minutes. Touch the TIMER pad. Touch the + or - pads until the amount of time you want shows in the display. The maximum time that can be entered in minutes is 59. Times more than 59 minutes should be changed to hours and minutes. If you make a mistake, touch the TIMER pad and begin again. Touch the START/ON pad. The time will start counting down, although the display does not change until one minute has passed. When the timer reaches :00, the control will beep 3 times followed by one beep every 6 seconds until the TIMER pad is touched. To Reset the Timer If the display is still showing the time remaining, you may change it by touching the TIMER pad, then touching the + or - pads until the time you want appears in the display. If the remaining time is not in the display (clock, delay start set time or cooking time are in the display), recall the remaining time by touching the TIMER pad and then touching the + or - pads to enter the new time you want. To Cancel the Timer Touch the TIMER pad twice. 15