GE JKP90SPSS Quick Specs - Page 1

JKP90SP GE® 27" Built-In Double Microwave/Thermal Wall Oven 10 D tion E Dimensions and Installation Information (in inches) KW RaAting 240V 6.4 208V 4.8 BreakeCr Size 240V 30 Amps Allow 3/4" for overlap of oven over all edges of cutout 208V 30 Am2"pXs4" or B equiv. runners H Note: Cabinets installed adjacent to wall ovens must have an adhesion sGpec of at least a 194°F temperature rating. Note: if marks, blemishes or the cutout opening is visible above the installed oven, it may be n21ecessary to add wood sChoinmdusitunder the runners and front trim (48-1/2" until the marksloonrg)openinFgs are covered. NCaobtein:eDtosoarA2n1hldlo"adwfnordramlcweilneepiamrrrsouatomnrncueodafedsja3c"efnrotm45d°oaonrdfa9c0e°.walls should be tpolaacdejadcteontacvoorindeirnst,erference with the handle. drawers, walls, etc. Electric wall ovens are not approved for installation with a plug and receptacle. They must be hard wired in accordance with installation instructions. CL 2 x 4 or equivalent runners Suitable bracing to support runners 18" over centerline of cabinet (must support 275 lbs.) Cabinet 27" A - Cabinet width required 27" min. B - Minimum cabinet depth 23-5/8" C - Opening width 25" min. - 25-1/4" max D - Opening height 41-1/4" max E - Minimum cutout location from floor 22" Oven F - Overall depth* 23-5/8" G - Overall height with trim 43" - 43-7/8" Overall height without trim 42-1/8" H - Overall width 26-5/8" *Depth including door handle is approximately 26-7/10" min. to 26-8/10" max. 10 Recommended junction box locations. Locate junction box either 5" MIN. below cutout floor or 48" MIN. above cutout floor D Access from adjacent cabinet required Minimum cutout location E from floor Installation Information: Before installing, consult installation instructions packed with product for ­current dimensional data. Note: These ovens are not approved for stackable or side-by-side installations. For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000. A Allow 3/4" for overlap of oven over all edges of cutout C 2" X 4" or B equiv. runners H G 21 Conduit (48-1/2" long) F Allow minimum of 21" for clearance to adjacent corners, drawers, walls, etc. Sui bra to sup run Cabinet A - Ca B - M C - Op D - Op E- M Oven F - Ov G - Ov Ov H - Ov *Depth 26-8/10 All GE ranges are equipped with an Anti-Tip device. The installation of this device is an important, required step in the installation of the range. Specification Created 5/09 Listed by Underwriters Laboratories 320359