GE JNM1541DNBB Installation Instructions - Page 22
Installing the Charcoal Filter, continued
UPC - 084691171294
View all GE JNM1541DNBB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Installation Instructions C4. MOUNT THE OVEN (continued) 3 Attach the oven to the top cabinet by inserting 2 self-aligning screws through outer top cabinet holes. Turn two full turns on each screw. Be sure to keep power cord tight. Be careful not to pinch the cord, especially when mounting flush to bottom of cabinet. C5. WHEN REPLACING THE CHARCOAL FILTER If the model is not vented to the outside, the air will be recirculated through a disposable charcoal filter that helps remove smoke and odors. The charcoal filter should be replaced when it is noticeably dirty or discolored (usually after 6 to 12 months, depending on hood usage). See your Owner's Manual for the filter kit number. To replace the charcoal filter: 1 Remove 4 screws on top of grille using a Phillips screwdriver. 2 Open the door. 3 Remove the grille. Charcoal Filter 4 Tighten the two screws to the top of the oven completely. (While tightening screws, hold the oven in place against the wall and the top cabinet.) 5 Install grease filters. See the Owner's Manual packed with the oven. 4 Slide the old filter to the front of the oven and remove it. 5 Remove plastic and other outer wrapping from the new filter and install the new filter. When properly installed, the wire mesh of the filter should be visible from the front. 6 Replace the grille and the 4 screws. 7 Close the door. Insert mesh-side up 22