GE JP5030SJSS Installation Instructions

GE JP5030SJSS Manual

GE JP5030SJSS manual content summary:

  • GE JP5030SJSS | Installation Instructions - Page 1
    Installation 30" Electric Cooktop - Radiant Instructions Excludes Down-Draft Models If you have questions, call 800.GE.CARES or visit our website at: GEAppliances.com. In Canada, call 800.561.3344 or visit our website at: GEAppliances.ca. BEFORE YOU BEGIN Read these instructions completely and
  • GE JP5030SJSS | Installation Instructions - Page 2
    Instructions IMPORTANT SAFETY INSTRUCTIONS FOR YOUR SAFETY • For Personal Safety, remove house fuse or open circuit breaker before beginning installation. Failure to do so could result in serious injury or death. • Be sure your cooktop is installed properly by a qualified installer or service
  • GE JP5030SJSS | Installation Instructions - Page 3
    Both products must be installed according to their specific product installation instructions. Consideration must be given the separate electrical requirements and locations: Over one or two wall ovens: • Only certain models may be installed over wall ovens. The wall oven and cooktop will both have
  • GE JP5030SJSS | Installation Instructions - Page 4
    the dimensions shown, up to 29-13/16" x 20-7/16". Order JXTR32X to reduce the cutout opening for installation of this cooktop. This kit may be ordered from your GE Dealer. For models with no drop box, allow 5" minimum depth between the countertop and an enclosure. (JP3530 and JP3030) For electronic
  • GE JP5030SJSS | Installation Instructions - Page 5
    Installation Instructions INSTALLING THE COOKTOP 1 INSTALLING THE JUNCTION BOX Install an approved junction box where it will be easily reached through the front of the cabinet where the cooktop will be located. The cooktop conduit is 4 feet long. 3 ATTACH FOAM TAPE Apply the foam tape around the
  • GE JP5030SJSS | Installation Instructions - Page 6
    Installation Instructions INSTALLING THE COOKTOP (CONT.) 4 LOCATE MOUNTING PARTS (Cont.) Alternate Installation: You can order an alternate installation kit WB01X25470 with wing nuts and brackets from your dealer. See diagram for instructions. Open the cabinet door. Install the second screw through
  • GE JP5030SJSS | Installation Instructions - Page 7
    Installation Instructions ,167$//$7,21³(/(&75,&$/&211(&7,216 GROUNDING INSTRUCTIONS: The bare ground wire in the conduit is connected to the cooktop frame. Effective January 1, 1996, the National Electrical Code will not permit grounding through neutral. If used in new construction after January 1,
  • GE JP5030SJSS | Installation Instructions - Page 8
    Installation Instructions 1 PRE-TEST CHECKLIST A Remove all protective film, if present, and any stickers. B Check to be sure that all wiring is secure and not pinched or in contact with moving parts. C Check level of appliance. D Check that the cooktop RESULT IN A SERIOUS PROBLEM. • Splice copper
  • GE JP5030SJSS | Installation Instructions - Page 9
    30" de instalación Radiante Excluye los Modelos de Flujo Descendente "Si tiene alguna pregunta, llame al 800.GE NO está cubierto bajo la garantía. PARTES INCLUIDAS NECESITARÁ LOS SIGUIENTES MATERIALES Caja de de 1/8" y taladro eléctrico o manual Gafas de seguridad 4 Tornillos (WB01X1137)
  • GE JP5030SJSS | Installation Instructions - Page 10
    Instrucciones de instalación INSTRUCCIONES DE SEGURIDAD IMPORTANTES PARA SU SEGURIDAD • Para su seguridad personal, retire los fusibles de su hogar o bien desconecte el cortacircuitos antes de comenzar con la instalación. El no hacerlo puede resultar en lesiones serias o incluso la muerte. • Asegú
  • GE JP5030SJSS | Installation Instructions - Page 11
    úrese de colocar todo el material impreso, Manual de propietario, Instalaciones, etc., en un (Consulte la sección de requisitos eléctricos). F Cuando instale la estufa en su hogar, asegúrese de cumplir todos los libre. Si no puede mantenerse un espacio de 30" entre la superficie de cocción y los
  • GE JP5030SJSS | Installation Instructions - Page 12
    4-3/16" Parte posterior en la ubicación del conducto (JP3530, JP3030) 19-1/4" 28" Parte Trasera de 6" en Modelos con Tecla Electrónica para reducir la abertura cortada. Puede solicitar este juego a su distribuidor de GE. Con los modelos sin buzón, deje un espacio vertical de por lo menos
  • GE JP5030SJSS | Installation Instructions - Page 13
    LA CINTA DE ESPUMA Aplique la cinta de espuma alrededor del borde externo del vidrio. No superponga la cinta de espuma. Parte inferior de la estufa Cinta de espuma 16" Mín. Instale la caja de conexiones de modo que pueda alcanzarse a través del frente del gabinete. IMPORTANTE: La caja de conexiones
  • GE JP5030SJSS | Installation Instructions - Page 14
    y soportes llamando al 800.GE.CARES. Para acceder a instrucciones, consulte el diagrama. Abra la puerta del gabinete. Instale el segundo tornillo a través del soporte y ajuste. Luego ajuste el primer tornillo. Instale el tornillo de mariposa hasta que toque la parte inferior de la mesada. Anafe
  • GE JP5030SJSS | Installation Instructions - Page 15
    Instrucciones de instalación INSTALACIÓN³&21(;,21(6(/e&75,&$6 INSTRUCCIONES PARA DESCARGA A TIERRA: El cable pelado de descarga a tierra en el conducto se conecta al armazón de la estufa. A partir del 1 de enero de 1996, el Código Nacional sobre Electricidad no permitirá la descarga a tierra a trav
  • GE JP5030SJSS | Installation Instructions - Page 16
    todos los cables estén fijos y que no estén torcidos o en contacto con partes móviles. C Verifique el nivel del aparato. D Verifique que la estufa esté B Encienda la toma de corriente de la estufa. (Consulte su Manual del propietario). Verifique que todas las hornillas de la superficie funcionen
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

1
TOOLS YOU WILL NEED
MATERIALS YOU WILL NEED
31-10985
(01-15
GE)
Installation
30” Electric Cooktop - Radiant
Instructions
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
Save these instructions
for local inspector’s use.
IMPORTANT
Observe all governing
codes and ordinances.
Note to Installer –
Be sure to leave these
instructions with the Consumer.
Note to Consumer –
Keep these instructions for
future reference.
Product failure due to improper installation is not
covered under the Warranty.
WARNING
This appliance must be
properly grounded.
ATTENTION INSTALLER
ALL
COOKTOPS MUST BE HARD WIRED (DIRECT
WIRED) INTO AN APPROVED JUNCTION BOX. A
“PLUG AND RECEPTACLE” IS NOT PERMITTED
ON THESE PRODUCTS.
Proper installation is the responsibility of the
installer and product failure due to improper
installation is NOT covered under warranty.
Wire Nuts
Junction Box
Saber Saw
Pencil
Safety Glasses
1/8” Drill Bit & Electric or
Hand Drill
Ruler or Straightedge
Phillips Head
Screwdriver
Excludes Down-Draft Models
If you have questions, call 800.GE.CARES or visit our website at: GEAppliances.com.
In Canada, call 800.561.3344 or visit our website at: GEAppliances.ca.
PARTS INCLUDED
2 Hold Down
Brackets
4 Screws
(WB01X1137)
Foam Tape
WB06K5042
90º or Straight
Squeeze Connector
for 1” Conduit