GE JRP28BJBB Use and Care Manual - Page 11

Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support GEAppliances.com Tones at the End of a Timed Cycle At the end of a timed cycle, 3 short beeps will sound followed by one beep every 6 seconds until the CLEAR/OFF pad is touched. This continuous 6 second beep may be canceled. To cancel the 6 second beep: Touch the BAKE and BROIL HI/LO pads at the same time for 3 seconds until the display shows SF. Touch the BROIL HI/LO pad. The display shows CON BEEP (continuous beep). Touch the BROIL HI/LO pad again. The display shows BEEP. (This cancels the one beep every 6 seconds.) Touch the START pad. NOTE: This feature is not available for the lower oven. 12 Hour, 24 Hour or Clock Black-Out Your control is set to use a 12 hour clock. If you would prefer to have a 24 hour military time clock or black-out the clock display, follow the steps below. Touch the BAKE and BROIL HI/LO pads at the same time for 3 seconds until the display shows SF. Touch the TIMER/CLOCK pad once. The display will show 12 hr. If this is the choice you want touch the START pad. Touch the TIMER/CLOCK pad again to change to the 24 hour military time clock. The display will show 24 hr. If this is the choice you want touch the START pad. Touch the TIMER/CLOCK pad again to black-out the clock display. The display will show OFF. If this is the choice you want touch the START pad. NOTE: If the clock is in the black-out mode you will not be able to use the Delay Start function. Cook and Hold Your new control has a cook and hold feature that keeps cooked foods warm for up to 3 hours after Timed Baking or Roasting is finished. NOTE: This feature can only be programmed to work with Timed Baking or Roasting. (See the Using the timed baking and roasting features section.) After Timed Baking or Roasting has automatically stopped, the programmed Cook and Hold will automatically start. To activate this feature for use after Timed Baking or Roasting, follow the steps below. Touch the BAKE and BROIL HI/LO pads at the same time for 3 seconds until the display shows SF. Touch the COOKING TIME pad. The display will show Hld OFF. Touch the COOKING TIME pad again to activate the feature. The display will show Hld ON. Touch the START pad to activate the cook and hold feature and leave the control set in this special features mode. NOTE: This feature is not available for the lower oven. Changing the Speed of the + or - Pads As you use the + or - pad when setting a time or temperature, you may notice the display changes slowly. This special feature allows you to change the speed. To set the speed you prefer, follow the steps below. Touch the BAKE and BROIL HI/LO pads at the same time for 3 seconds until the display shows SF. Touch the + pad. The display will show you a set speed between 1 and 5. Touch the + pad to increase the speed up to the number 5. Touch the - pad to decrease the speed down to the number 1. Touch START to activate the setting and leave the control set in this special features mode. 11