GE JRS06BJBB Use and Care Manual - Page 20

Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions Before you call for service... Troubleshooting Tips Problem "F- and a number or letter" flash in the display Display goes blank Display flashes Unable to get the display to show "SF" Power outage, clock flashes "Burning" or "oily" odor emitting from the vent Strong odor Fan noise Possible Causes You have a function error code. If the function code repeats. What To Do • Touch the CLEAR/OFF pad. Allow the oven to cool for one hour. Put the oven back into operation. • Disconnect all power to the oven for at least 30 seconds and then reconnect power. If the function error code repeats, call for service. A fuse in your home may be blown or the circuit breaker tripped. The clock is in the black-out mode. • Replace the fuse or reset the circuit breaker. • See the Special features of your oven control section. Power failure. • Reset the clock. Oven control pads were not pressed properly. • The BAKE and BROIL HI/LO pads must be touched at the same time and held for 3 seconds. Power outage or surge. • Reset the clock. If the oven was in use, you must reset it by touching the CLEAR/OFF pad, setting the clock and resetting any cooking function. This is normal in a new oven and will disappear in time. • To speed the process, set a self-clean cycle for a minimum of 3 hours. See the Using the self-cleaning oven section. An odor from the insulation around the inside of the oven is normal for the first few times the oven is used. • This is temporary. A cooling fan may automatically turn on. • This is normal. The cooling fan will turn on to cool internal parts. It may run for up to 2 hours after the oven is turned off. 20