GE JSP39SNSS Use and Care Manual - Page 23

Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support Using the self-cleaning oven. (on some models) GEAppliances.com Self Clean Start Time How to Delay the Start of Cleaning (on some models) Make sure the clock shows the correct time of day. Latch the door. Touch the Self Clean pad. Using the + or - pads, enter the desired clean time. The display will show the start time. It will not be possible to unlatch the oven door until the temperature drops below the lock temperature. The oven shuts off automatically when the clean cycle is complete, and 0:00 will flash in the display. Touch the Start Time pad. The earliest start time you can set will appear in the display. Using the + or - pads, enter the time of day you want the clean cycle to start. Touch the Start/On pad. Start On To Stop a Clean Cycle Touch the Clear/Off pad. Wait until the oven has cooled below the locking temperature to unlatch the door. You will not be able to open the door right away unless the oven has cooled below the locking temperature. After a Clean Cycle You may notice some white ash in the oven. Wipe it up with a damp cloth after the oven cools. If white spots remain, remove them with a soap-filled steel wool pad and rinse thoroughly with a vinegar and water mixture. These deposits are usually a salt residue that cannot be removed by the clean cycle. If the oven is not clean after one clean cycle, repeat the cycle. ■ You cannot set the oven for cooking until the oven is cool enough for the door to be unlatched. ■ While the oven is self-cleaning, you can press the Clock pad to display the time of day. To return to the clean countdown, press the Self Clean pad. ■ Apply a small amount of vegetable oil to a paper towel and wipe the edges of the oven racks with the paper towel. Do not spray with Pam® or other lubricant sprays. 23