GE JT5500SFSS Installation Instructions - Page 3
Cutout For Double Ovens, Thermal Ovens, Cutout For Installation Over A Warming Drawer - installation instructions
View all GE JT5500SFSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
2 C CUTOUT FOR DOUBLE OVENS (2 THERMAL OVENS) NOTE: If the cabinet does not have a front frame and the sides are less than ¾" (1.9 cm) thick, shim both sides equally to establish the cutout Hwidth. Junction B Box Location (junction box may be located in adjacent cabinet) F D J C G E Cutout Depth 23-1/2" K (59.7 cm) Min. A Dim. Description A Cabinet Width B Cutout Width C Cutout Height D Overlap of Oven Over Side Edges of Cutout E Clearance to Adjacent Corners, Drawers, Walls, etc., When Door Is Open F Overlap of Oven Top of Cutout G Overlap of Oven Bottom of Cutout H Junction Box Location J Height to Bottom of Junction Box K Recommended Cutout Location from Floor Continue to Section 3. 27" Double Oven 27" (68.6 cm) 25" (63.5 cm) min. 251⁄4" (64.1 cm) max. 4911⁄16" (126.2 cm) min. 501⁄8" (127.3 cm) max. 1" (2.5 cm) 23" (50.8 cm) min. 1" (2.5 cm) min. 1" (2.5 cm) min. 83⁄4" (22.2 cm) max. right side only 44" (111.8 cm) 131⁄4" (33.7 cm) 30" Double Oven with Pedestal 30" (76.2 cm) 281⁄2" (72.4 cm) min. 285⁄8" (72.7 cm) max. 5113⁄16" (131.6 cm) min. 5115⁄16" (131.9 cm) max. 11⁄16" (1.75 cm) 23" (53.3 cm) min. 1" (2.5 cm) min. (11⁄4" (3.2 cm) for PT9550) 11⁄4" (3.2 cm) 91⁄2" (24.1 cm) max. right side only 47" (119.4 cm) 12" (30.5 cm) 30" Double Oven without Pedestal 30" (76.2 cm) 281⁄2" (72.4 cm) min. 285⁄8" (72.7 cm) max. 50 ¼" (127.64cm) 11⁄16" (1.75 cm) 23" (53.3 cm) min. 1" (2.5 cm) min. (11⁄4" (3.2 cm) for PT9550) 11⁄4" (3.2 cm) 91⁄2" (24.1 cm) max. right side only 47" (119.4 cm) 12" (30.5 cm) 31-10856-1 04-13 GE 2 D CUTOUT FOR INSTALLATION OVER A WARMING DRAWER NOTE: Install the oven only with specific models listed on the label located on top of the oven. NOTE: Additional clearances between cutouts may be required. Check to be sure the oven supports above the Warming Drawer location do not obstruct the required interior depth and height. When installing a Warming Drawer below a single or double oven, a separate 120V, 60 HZ, properly grounded receptacle must be installed. Refer to installation instructions packed with the Warming Drawer for specific installation requirements. Anti-Tip Block Against Rear Wall Per Warming Drawer Requirement 2" (5.1 cm) Min. Per Warming Drawer Requirement Continue to Section 3 for DWO with Pedestal. Otherwise, continue to Section 4.