GE JT912BFBB User Manual - Page 28
Problem, Possible Causes, What To Do, BROIL HI/LO
View all GE JT912BFBB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions Before You Call For Service... Troubleshooting Tips Problem "F- and a number or letter" flash in the display Display goes blank Display flashes Unable to get the display to show "SF" "PROBE" appears in the display Power outage, clock flashes Steam from the vent "Burning" or "oily" odor emitting from the vent Strong odor Fan noise Possible Causes What To Do You have a function error code. • Press the CLEAR/OFF pad. Allow the oven to cool for one hour. Put the oven back into operation. If the function code repeats. • Disconnect all power to the oven for at least 30 seconds and then reconnect power. If the function error code repeats, call for service. A fuse in your home may be blown or the circuit breaker tripped. The clock is in the black-out mode. • Replace the fuse or reset the circuit breaker. • See the Special features of your oven control section. Power failure. • Reset the clock. Oven control pads were not pressed properly. • The BAKE and BROIL HI/LO pads (on double oven models, use the upper oven controls) must be pressed at the same time and held for 3 seconds. This is reminding you to enter a probe temperature after plugging in the probe. • Enter a probe temperature. Power outage or surge. • Reset the clock. If the oven was in use, you must reset it by pressing the CLEAR/OFF pad, setting the clock and resetting any cooking function. When using the convection • This is normal. feature, it is normal to see steam coming out of the oven vent. As the number of shelves or amount of food being cooked increases, the amount of visible steam will increase. This is normal in a new oven • To speed the process, set a self-clean cycle for a and will disappear in time. minimum of 3 hours. See the Using the self-cleaning oven section. An odor from the insulation around the inside of the oven is normal for the first few times the oven is used. • This is temporary. A cooling fan or a convection fan (depending on the function you are using) may automatically turn on. • This is normal. The cooling fan will turn on to cool internal parts. It may run for up to 1-1/2 hours after the oven is turned off. The convection fan will cycle on and off until the function is over or the door is opened. 28