GE JVM1650CH Installation Instructions - Page 21
Mount the Microwave Oven
View all GE JVM1650CH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Installation Instructions C4. ADAPTING MICROWAVE BLOWER FOR RECIRCULATION (cont.) 7 Place the blower unit back into the opening. CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. NOTE: When mounting the microwave oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1-3. Do not pinch cord or lift oven by pulling cord. 1 Lift microwave, tilt it forward, and hook slots at back bottom edge onto four lower tabs of mounting plate. 8 Secure blower unit to microwave with the screw removed in Step 4. 9 Replace blower plate with the screw removed in Step 1. Back of Microwave C5. MOUNT THE MICROWAVE OVEN 2 Rotate front of oven up against cabinet bottom. 3 Insert a self-aligning screw through top center cabinet hole. Temporarily secure the oven by turning the screw at least two full turns after the threads have engaged. (It will be completely tightened later.) Be sure to keep power cord tight. Be careful not to pinch the cord, especially when mounting flush to bottom of cabinet. Cabinet Front Cabinet Bottom Shelf Filler Block Equivalent to Depth of Cabinet Recess FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE INSTALL THIS MICROWAVE OVEN. IMPORTANT: Do not grip or use handle during installation. NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord. NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf. IMPORTANT: If filler blocks are not used, case damage may occur from overtightening screws. Self-Aligning Screw Microwave Oven Top 4 Attach the microwave oven to the top cabinet. 21