GE JVM1650SH User Manual - Page 42

If Something Goes Wrong Before You Call For Service Problem Possible Cause What to Do Oven will not start Floor of the oven is warm, even when the oven has not been used "LOCKED" appears on display You hear an unusual, low-tone beep "SENSOR ERROR" appears on display Food amount too large for Sensor Reheat A fuse in your home • Replace fuse or reset circuit breaker. may be blown or the circuit breaker tripped. Power surge. • Unplug the microwave oven, then plug it back in. Plug not fully inserted • Make sure the 3-prong plug on the into wall outlet. oven is fully inserted into wall outlet. Door not securely closed. • Open the door and close securely. Heat from the cooktop • This is normal. light may make the oven floor get warm. The control has been locked. • Press and hold CLEAR/OFF for about 3 seconds to unlock the control. You have tried to start the Reminder without a valid time of day. • Start over and enter a valid time of day. You have tried to change • Many of the oven's features are preset the power level when it is and cannot be changed. not allowed. When using a Sensor feature, the door was opened before steam could be detected. • Do not open door until steam is sensed and time is shown counting down on display. Steam not detected in maximum amount of time. • Use Time Cook to heat for more time. Sensor Reheat is for single servings of recommended foods. • Use Time Cook for large amounts of food. "BAD PROBE" or "PLEASE INSERT PROBE" appears on display Probe has been forgotten or may not be inserted properly into oven outlet. • Insert the probe properly into the oven wall outlet. The probe is defective. • Replace the probe. 42