GE JVM2070WH Installation Instructions - Page 22
Installing the Charcoal Filter
![]() |
View all GE JVM2070WH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Installation Instructions C5. MOUNT THE MICROWAVE OVEN (cont.) 5 Insert 2 self-aligning screws through outer top cabinet holes. Turn two full turns on each screw. C6. INSTALLING THE CHARCOAL FILTER 1 Remove screws on top front of grille using a #2 Phillips screwdriver. 2 Open the door. 3 Remove the grille. Slide the grille to the left and pull it straight off. Charcoal Filter 6 Tighten center screw completely. 7 Tighten the outer two screws to the top of the microwave oven. (While tightening screws, hold the microwave oven in place against the wall and the top cabinet.) 4 Install the charcoal filter. When properly installed, the wire mesh of the filter should be visible from the front. 5 Replace the grille and the screws. 6 Close the door. 8 Install grease filters. See the Owner's Manual packed with the microwave. Insert mesh-side up 22
![](/manual_guide/products/general-electric-jvm2070wh-installation-instructions-2796bc3/22.png)