GE JVM2070WH Dimensions - Page 2

GE Profile, Spacemaker, 0 Cu. Ft. Over-the-Range Microwave Oven - microwave filter

Page 2 highlights

JVM2070BH/CH/SH/WH GE Profile™ Spacemaker® 2.0 Cu. Ft. Over-the-Range Microwave Oven Dimensions and Installation Information (in inches) Hood Exhaust Duct: Outside ventilation requires a HOOD EXHAUST DUCT. Read the following carefully. Exhaust Connection: The hood exhaust has been designed to mate with a standard 3-1/4" x 10" rectangular duct. If a round duct is required, a rectangular-to-round transition adaptor must be used. Do not use less than a 6" diameter duct Rear Exhaust: If a rear or horizontal exhaust is to be used, care should be taken to align exhaust with space between studs, or wall should be prepared at the time it is constructed by leaving enough space between the wall studs to accommodate exhaust. Maximum Duct Length: For satisfactory air movement, the total duct length of 3-1/4" x 10" rectangular or 6" diameter round duct should not exceed 120 equivalent feet. Elbows, Transitions, Wall and Roof Caps, etc., present additional resistance to airflow and are equivalent to a section of straight duct which is longer than their actual physical size. When calculating the total duct length, add the equivalent length of all transitions and adaptors plus the lengths of all straight duct sections. The chart below shows the approximate feet of equivalent length of some typical ducts. Optional Accessories (Available at additional cost) Filler Panel Kits JX40CT-Bisque JX41-Black JX40WH-White When replacing a 36" or 42" range hood, this kit fills in the additional width to provide a custom built-in appearance. For installation between ­cabinets only; not for end-of-cabinet installation. Each kit ­contains two 3"-wide filler panels. Two kits are needed for a 42" opening. Decorative Panel Kits Duct A. Rectangular-To-round Transition Adaptor B. Wall Cap C. 90° Elbow D. 45° Elbow E. 90° Elbow F. 45° Elbow G. Roof Cap Equivalent Feet 5 ft. 40 ft. 10 ft. 5 ft. 25 ft. 5 ft. 24 ft. For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000. JX22SS-Stainless Steel Decorative Panel Kit When replacing a Hi/Low range with a microwave/convection oven or Spacemaker over a range model, this panel kit fills in the area between the microwave and range left by the Hi/Low model. 3/8" depth 30 Filter KitsJX81H- Recirculating Charcoal Filter Kit To be used when the Spacemaker microwave oven cannot be vented to the outside. 19 Listed by Underwriters Laboratories Specification Revised 8/07 240296

  • 1
  • 2
  • 3

For answers to your Monogram,
®
GE Profile
or
GE
®
appliance questions, visit our website at
ge.com or call GE Answer Center
®
service,
800.626.2000.
240296
Specification Revised 8/07
Listed by
Underwriters
Laboratories
JVM2070BH/CH/SH/WH
GE Profile
Spacemaker
®
2.0 Cu. Ft. Over-the-Range Microwave Oven
Hood Exhaust Duct:
Outside ventilation requires a HOOD EXHAUST DUCT. Read the
following carefully.
Exhaust Connection:
The hood exhaust has been designed to mate with a standard
3-1/4" x 10" rectangular duct. If a round duct is required, a rectangular-to-round transition
adaptor must be used. Do not use less than a 6" diameter duct
Rear Exhaust:
If a rear or horizontal exhaust is to be used, care should be taken to
align exhaust with space between studs, or wall should be prepared at the time it is
constructed by leaving enough space between the wall studs to accommodate exhaust.
Maximum Duct Length:
For satisfactory air movement, the total duct length of
3-1/4" x 10" rectangular or 6" diameter round duct should not exceed 120 equivalent feet.
Elbows, Transitions, Wall and Roof Caps
, etc., present additional resistance to airflow
and are equivalent to a section of straight duct which is longer than their actual physical
size. When calculating the total duct length, add the equivalent length of all transitions
and adaptors plus the lengths of all straight duct sections. The chart below shows the
approximate feet of equivalent length of some typical ducts.
Duct
Equivalent Feet
A.
Rectangular-To-round
5 ft.
Transition Adaptor
B.
Wall Cap
40 ft.
C.
90° Elbow
10 ft.
D.
45° Elbow
5 ft.
E.
90° Elbow
25 ft.
F.
45° Elbow
5 ft.
G.
Roof Cap
24 ft.
Optional Accessories (Available at additional cost)
Filler Panel Kits
JX40CT–Bisque
JX41–Black
JX40WH–White
When replacing a
36" or
42" range hood, this kit fills
in the additional width to
provide a custom built-in
appearance. For installation
between cabinets only; not
for end-of-cabinet installation.
Each kit contains two 3"-wide
filler panels. Two kits are needed
for a 42" opening.
Filter KitsJX81H–
Recirculating Charcoal
Filter Kit
To be used when
the Spacemaker
microwave oven
cannot be vented
to the outside.
Dimensions and Installation Information (in inches)
19
30
3/8"
depth
JX22SS-Stainless Steel
Decorative Panel Kit
When replacing a
Hi/Low range with
a microwave/convection oven or
Spacemaker over a range model, this
panel kit fills in the area between the
microwave and range left by the
Hi/Low model.