GE JVX3300SJSS Use and Care Manual - Page 17
Remove Electrical, Knockouts, Remove Junction Box, Remove Duct Knockouts, For Vented Installation,
View all GE JVX3300SJSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
INSTALLATION PREPARATION Installation Preparation 4 REMOVE ELECTRICAL KNOCKOUTS Use a flat blade screwdriver, remove the appropriate electrical knockout from the back or the top of the hood. 6 REMOVE DUCT KNOCKOUT(S) FOR VENTED INSTALLATION Determine which ducting option to use. Using a flat blade screwdriver, remove the appropriate duct knockout(s) from the top or back of the hood. 3 1»4" x 10" Rectangular vertical discharge. Remove top rectangular duct knockout only. 7" Round vertical discharge. Remove semi-circular duct knockout and top rectangular duct knockout. 5 REMOVE JUNCTION BOX Remove junction box from inside the hood. Set the junction box and mounting screws aside. Junction Box Screws 3 1»4" x 10" Rectangular horizontal discharge. Remove rear rectangular duct knockout only. NOTE: If the hood is to be installed in a recirculation, non-vented ductless manner, do not remove any venting knockouts. NOTE: For an ENERGY STAR® model, unit must be vented mode to be considered ENERGY STAR® certified. 7 ATTACH DAMPER/DUCT CONNECTOR Attach damper/duct connector over knockout opening with two or four (D) screws. Make sure damper pivot is nearest to top/back edge of hood. Remove any packaging tape to allow damper to move freely. Tape 7RSEDFN edge Damper (vertical discharge position shown) Rectangular Ducting 7" round exhaust adaptor 49-80783-3 Round Ducting 17