GE P2S975DEPBB Installation Instructions - Page 9
Warning
UPC - 084691199717
View all GE P2S975DEPBB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Installation Instructions 15 4-WIRE POWER CORD INSTALLATION WARNING: The neutral wire of the supply circuit must be connected to the neutral terminal located in the lower center of the terminal block. The power leads must be connected to the lower left and the lower right terminals of the terminal block. The ground lead must be connected to the frame of the range with the ground plate and the ground screw. A Remove the 3 lower terminal screws from the terminal block. Remove the ground screw and ground plate and retain them. B Cut and discard the ground strap. DO NOT DISCARD ANY SCREWS. C Insert the one ground screw into the power cord ground wire terminal ring, through the ground plate and into the frame of the range. D Insert the 3 terminal screws (removed earlier) through each power cord terminal ring and into the lower terminals of the terminal block. Be certain that the center wire (white/ neutral) is connected to the center lower position of the terminal block. Tighten screws securely into the terminal block. Before Terminal block Ground strap After Terminal block Ground strap or Neutral terminal Ground plate (grounding to range) Ground screw E Skip to Step 18 and proceed with the installation. 16 3-WIRE CONDUIT INSTALLATION A Loosen the 3 lower terminal screws from the terminal block. Insert the center bare wire (white/neutral) tip through the bottom center terminal block opening. On certain models, the wire will need to be inserted through the ground strap opening and then into the bottom center block opening. Insert the two side bare wire tips into the lower left and the lower right terminal block openings. Tighten the screws until the wire is firmly secured (35 to 50 inch-lbs.). Do not overtighten the screws since it could damage the wires. NOTE: ALUMINUM WIRING: Aluminum building wire may be used but it must be rated for the correct amperage and voltage to make connection. Connect wires according to this Step 16 or Step 17 depending on number of wires. Terminal block Wire tips Bracket Conduit Wire used, location and enclosure of splices, etc., must conform to good wiring practices and local codes. B Skip to Step 18 and proceed with the installation. 9