GE PD968 Installation Instructions - Page 1

Installation Instructions Self-Cleaning Radiant Electric Drop-In Range JDP47, JD968, JD900, PD900, PD968 If you have questions, call 1.800.GE.CARES or visit our website at: GEAppliances.com Before You Begin Read these instructions carefully and completely. • IMPORTANT-Save these instructions for local inspector's use. • IMPORTANT-Observe all governing codes and ordinances. • Note to Installer-Be sure to leave these instructions with the consumer. • Note to Consumer-Keep these instructions for future reference. • Proper installation is the responsibility of the installer and product failure due to improper installation is NOT covered under the warranty. • NOTE-This appliance must be properly grounded. • ATTENTION INSTALLER All electric drop-in ranges must be hard wired (direct wired) into an approved junction box. A plug and receptacle is NOT permitted on these products. Parts Included Tools You Will Need 2 Shoulder Screws (for stop device) Lower Trim 4 Screws Materials Needed 1/8" Drill Bit and Electric or Hand Drill Level Tape Measure Phillips Screwdriver Standard Screwdriver Nut Driver Junction Box Strain Relief Clamp for 1/2" conduit Wire Nuts Straight Edge or Square Hammer Pencil 31-10622-3 02-10 Hand or Sabre Saw 1 Safety Glasses