GE PDW1800NII Use and Care Manual - Page 13

Safety Instructions Operating Instructions Care Instructions Troubleshooting Tips Consumer Support Problem Possible Causes Dishwasher won't run Fuse is blown, or the circuit breaker tripped Power is turned off Reboot your control Steam This is normal Control panel responded to input but dishwasher never filled with water Door latch may not be properly seated Water valve may be turned off Dishwasher beeps once every 15 seconds This is normal This is a reminder that the door has been left open during operation Beeping at the end of the cycle This is normal LOW RINSE AID light is on Rinse aid dispenser needs to be refilled ge.com What To Do • Replace fuse or reset circuit breaker. Remove any other appliances from the circuit. • In some installations, the power to the dishwasher is proved through a wall switch, often located next to the disposer switch. Make sure it is on. • Turn off power to the dishwasher (at circuit breaker or wall switch) for 30 seconds, then turn back on. • Steam comes through the vent during washing, drying and when water is being pumped out. • Make sure the door is firmly closed. • Make sure water valve (usually located under the sink) is turned on. • Close the door after opening it mid-cycle. • Press ON/OFF to turn OFF the dishwasher. • The dishwasher will beep and the CLEAN light will display at the end of the wash cycle. • This can only be turned off by filling the rinse aid dispenser with Jet-Dry® or Cascade Crystal Clear®. See Refilling the Rinse Aid Dispenser section. 13