GE PDW8900N Owners Manual - Page 18
Problem, Possible Causes, What To Do, Top Control Panel models only
View all GE PDW8900N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Safety Instructions Operating Instructions Before you call for service... Troubleshooting Tips Problem Possible Causes What To Do Dishwasher won't run Fuse is blown or circuit breaker is tripped Power is turned off Control panel lights go off when you're setting controls Water standing in the bottom of the tub Water won't pump out of the tub Control panel is locked Control panel needs to be rebooted Time too long between touching of selected pads This is normal Drain is clogged Steam This is normal Sanitized light does not illuminate at the end of the cycle (Anti-Bacteria cycle only) Noise The door was opened and the cycle was interrupted during or after the main wash portion The incoming water temperature was too low Normal operating sounds • Replace fuse or reset circuit breaker. Remove any other appliances from the circuit. • In some installations, the power to the dishwasher is provided through a wall switch, often located next to the disposer switch. Make sure it is on. • Unlock control panel. See page 6. • Turn off power to the dishwasher (circuit breaker or wall switch) for 30 seconds; then turn back on. • Each pad must be touched within 5 minutes of the others. To relight, touch any pad again, or unlock and relatch door. • A small amount of clean water around the outlet on the tub bottom at the back of the tub keeps the pump seal lubricated. • If you have an air gap, clean it. See page 15. • If the dishwasher drains into a disposer, run disposer clear. • Check to see if your kitchen sink is draining well. If not, you may need a plumber. • Warm, moist air comes through the vent by the door latch during drying and when water is being pumped out. This is necessary for drying. • Do not interrupt the cycle anytime during or after main wash. • Raise the water heater temperature to between 120°F and 140°F. • These are all normal. No action is required. Detergent cup opening Water entering dishwasher The motor stops and starts at various times during the cycle Drain pump sounds during pump out Drying fan running for 2-4 hours after CLEAN light is illuminated (Top Control Panel models only) Rattling dishes when the spray arm rotates • Make sure dishes are properly loaded. See the Loading the dishwasher racks section. Troubleshooting Tips Consumer Support 18