GE PDWT500R Owners Manual - Page 9
Flashing display lights., Recommended dishwasher products. - profile
View all GE PDWT500R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
6EAppliances.com E"j| Start (continued) Top-Control Dishwashers After selecting the cgcle and desired enhancements, touch the START/RESETpod to reodg the dishwasher to begin the cgcle. Closethe door to start the cgcle or begin the DELAVSTARTcountdown. When the cgcle starts, the water fill begins and opproximotelg 60 seconds later the wash action begins. The dishwasher will olwogs displog gour lost selection and enhancements. If gou don't wont to change the settings, simplg touch the START/RESEpTod to reodg the dishwasher and close the door to begin the cgcle. ALL MODELS:If o power failure occurs NORMALand HEATEDDRYwill outomoticollg be programmed. Make ong new selections and touch the START/RESETpod to begin the new cgcle. When the door is opened, the indicator lights will turn off if the START/RESETpodis not selected within 5 minutes. To activate the displog, open and close the door or touch ong pod. D Clean Front-Control Dishwasher The CLEANlight will illuminate and o double beep will sound when o wash cgcle is complete. On some models, the CLEAN light will turn off when the door is opened. On other models,the CLEANlight will remain on until the door is opened and then relotched or until ong kegpod is pressed while the door is latched shut. Top-Control Dishwasher The CLEANlight will illuminate and a double beep will sound when a wash cgcle is complete. The CLEAN light will remain on until the door is opened and then relatched or until any keg is pressed. ALL MODELST: o turn off the audible end-of-cycle signal (or re-activate it if it was previously turned off), press the HEATEDDRYpad 5 times within 5 seconds. A triple beep will sound to indicate the end-of-cycle beep option has been toggled. Flashing display lights. Status Indicator Lights START/RESET What It Means Cycle has been interrupted by pressing the START/RESETpad, or there has been a power failure. Light will stop flashing after the dishwasher automatically drains out the water. The dishwasher will restart with NORMAL and HEATEDDRY if the interruption was the result of a power failure. Recommended dishwasher products. GErecommends the following products for use in its dishwashers: • Foryour manual detergent dispenser,Cascade® powder, liquid or gel automatic dishwasher detergents are approved. • Cerama Bryte ®StainlessSteelAppliance Cleaner to clean the exterior stainless steel panel of GEand ProfileTM dishwashers (for stainless steel exterior models onlg). • Forgour SmartDispenseTM Detergent Dispenser,use onlg the recommended liquid automatic detergents listed on page 12 of this manual. • Cascade Crystal Clear ®rinse agents to remove spots and prevent new film buildup on gour dishes, glasses,flatware, cookware and plastic. Using rinse agent also improves drg performance.