GE PGP989SNSS Quick Specs - Page 2
GE Profile, Downdraft Gas Cooktop
UPC - 084691172550
View all GE PGP989SNSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
PGP989SN GE Profile™ 30" Downdraft Gas Cooktop Dimensions and Installation Information Installing the Ductwork: Use galvanized or aluminum duct in 6" round or 3-1/4" x 10" size, or combination of both. PVC duct or locally approved piping should be used if installing under a poured concrete slab. Local building code must be followed in specifying type and schedule of all duct used. Note: Ductwork must be vented to outside. Do not vent into a wall, ceiling, crawlspace, attic or any concealed space. Always use an appropriate roof or wall cap with damper. Laundry-type wall caps should never be used. For maximum efficiency use the shortest and straightest duct run possible, with as few fittings as possible. For satisfactory performance the duct run should not exceed 100 feet equivalent length. Refer to the table of equivalent lengths (shown in installation instructions) for various duct configurations. Through Cabinet Toe Space 10-1/8 Between Floor Joist 6-1/8 Venting Options Inside Wall to Roof Direct to Outside 9-1/8 18-3/4 For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000. Downward Venting Rear Wall Venting Dimension and installation information are shown in inches. Listed by Underwriters Laboratories Specification Revised 4/09 230285