GE PHP9030SJSS Quick Specs - Page 1

PHP9030SJ GE Profile™ Series 30" Built-In Touch Control Induction Cooktop Dimensions and Installation Information (in inches) Important: Requires a 5" free area between the bottom of the cooktop to any combustible material, i.e., shelving. Free area not required when installing wall oven underneath cooktop. Refer to installation instructions. Requires a 15" minimum from cooktop to adjacent overhead cabinets. Units are furnished with a 48" flexible armored cable. Approximate Cooking Dimensions PHP9030SJ 13" MAX. depth of unprotected overhead cabinets (when no hood or microwave is installed) 4-5/8" at baffle near center ofunit (except when installed above an approved wall oven) and 3-1/4" at rear of air intake 29-7/8" 21-1/2" Cooktop Note: 30" induction cooktops are approved for use over select GE 27" and GE 30" Single Wall Ovens and Warming Drawers. Refer to cooktop and wall oven/warming drawer installation instructions packed with product for current dimensional data. If installed with a GE Telescopic Downdraft System, consult both the cooktop and downdraft installation instructions packed with product before installing. Cooktop gas/electric supply may need to be re-routed to install downdraft. The countertop cutout requires 23-1/2" minimum flat countertop surface and 25" minimum total countertop depth. In addition, other clearances to front edge of the countertop must be considered. Before installing, consult installation instructions packed with product for ­current dimensional data. Cutout filler trim kit: A filler trim kit is available for use if your countertop cutout is larger than the dimension shown, up to 29-13/16" x 20-7/16". Order JXTR32B for black or JXTR32W for white, to reduce the cutout opening for installation of this cooktop. These kits may be ordered from your GE Dealer. 1-3/4" MIN. to rear wall 19-1/4" 28" 19-5/8" to 19-3/4" 28-1/2" to 28-5/8" 30" MIN. from countertop to unprotected cabinet (when no hood or microwave is installed) 2-1/2" MIN. Required To insure accuracy, it is best to make a template when cutting the opening in the counter Electrical junction box 16" MIN. below countertop 2" MIN. clearance to side wall from cut-out on both sides of cooktop KW Rating 240V 7.3 208V 6.4 Amperage 240V 30.8 Amps† 208V 30.8 Amps† †Note: Check local codes for required breaker size For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at geappliances.com or call GE Answer Center® service, 800.626.2000. 15" MIN. height from countertop to nearest cabinet (including light rails) on both sides of cooktop Listed by Underwriters Laboratories Specification Created 1/15