GE PSB2200NWW Quick Specs - Page 1

dvantium Wall Oven Dimensions (in inches)and abinet Installation (in inches) PSB2200N GE Profile Advantium® 240 Wall Oven Cutout width 4-3/16 25-1/8" Cabinet width 4-3/16 te: Cabinets inAsdtavlleadnadtjiaucemnt wall oven/GE Profile cooking tower dimensions and cabinet installation information (in inches) wall ovens must have an adhesion ec of at least 1N94o°tFete: mCpaerbatiunreertasting. 21-1/2" Excluding 23-1/2" installed adjacent Handle Cutout depth to wall ovens must have an adhesion spec of at least a 194°F temperature rating. 19-1/32" Junction box A B location (240-Volt H Conduit 17-1/2" models only) (48-1/2" long) Cutout height W Note: 2" minimum between cutouts when installed above warming drawer or single wall oven. Installation 29-25/32" Required cutout location 36-3/4" minimum from floor Construct Solid Bottom Min. 3/8" Plywood Supported by 2 x 4 or 1 x 2 Runners, all Four Sides. (Must Support 150 lbs.) Information: 30 Before installing, consult installation instructions packed with product for ­current dimensional data. A=Allow 1" overlap of oven over top and bottom edges of cutout. B=Allow 11/16"-3/4" for overlap ov oven over side edges of cutout. A B D Excluding Handle Conduit (46" long) A B Junction box location (240-volt models only) 2-1/2" MIN between cutouts recommended-2" MIN required Construct Solid Bottom MIN 3/8" Plywood Supported by 2 x 4 or 1 x 2 Runners, all Four Sides. (Must Support 150 lbs. for Advantium) (Must Support 200 lbs. for Wall Oven) 9-1/4" cutout height 28-1/2" cutout width 2" MIN between cutouts 1" Min. above toekick or adjust to oven installation height A=Allow 7/8" overlap of oven over bottom and 1/4" overlap at top edges of cutout. B=Allow 2-1/8" for overlap of oven over side edges of cutout. A=Allow 7/8" overlap of oven over bottom and 1/4" overlap at top edges of cutout. B=Allow 2-1/8" for overlap of oven over side edges of cutout. For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000. Suitable bracing to support runners CL 21-5/8" over centerline of cabinet (Must support 130 lbs.) 2 x 4's or equivalent solid floor D Cabaidnevt_240_W120_cookHtower_dDieap.tehps Width Width Height (excluding (inches) handle) X Cutout Width PSB2200/1 without accessory drawer 30 29-25/32 19-1/8 21-1/2 25-1/8 PSB2200/1 with accessory drawer 30 29-25/32 22-1/4 21-3/4 25-1/8 to 28-1/2* *For existing cutouts a maximum width of 28-1/2" is acceptable Y Cutout Height 17-1/2 21 Z Cutout Depth (minimum) 23-1/2 23-1/2 Listed by Underwriters Laboratories cooking_tower_solid_floor.eps Specification Created 9/08 240442