GE PZS23KPEWV Quick Specs - Page 3

PZS23KPE GE Profile™ Series 23.3 Cu. Ft. Counter-Depth Side-By-Side Refrigerator Rough-In Dimensions and Installation Information (in inches) Collar Trim Installation An enclosure is required to match up to the trim, see Typical Installation. To obtain the most integrated look, the cabinet or soffit above the refrigerator should extend out to the same depth as the side panels. The refrigerator opening must have minimum dimensions of 70" high x 36-1/8" wide x 24-1/2" deep as shown at right. If there is an overhead cabinet, allow 1" for cabinet door clearance with the top trim piece so the cabinet doors can be opened without hitting the top trim. If 1/2" side panels are used, then side trim and panel will be even. If 3/4" side panels are used, then some of the side panel will extend beyond the trim and must be finished. Typical Installation Shaded areas represent front surfaces of side panels and overhead cabinet or soffit that contacts trim. IMPORTANT: Before finalizing specifications for your GE Profile Counter-Depth Refrigerator, please NOTE: • A minimum of 36-1/8" is required for refrigerator installation with collar Refrigerator Case 3/4" Cabinet Side Panel 1/2" Cabinet Side Panel • B e sure to allow for 1/2" or 3/4" side Magnetic Tape panels in addition to the 36-1/8" minimum. Door Gasket Refer collar trim insStaildl e Trim Side trim must be installed flush with the gasket contact surface on the case. Overhead Cabinet Case Cabinet Door 1" Top Trim 1/2" minimum 70"* 24-1/2"* 36-1/8" *The rough-in dimension of 70" is minimum and is measured from the finished floor to top of opening (or the underside of the overhead cabinets). For Models with Trim Kit: If frameless style cabinets are planned for above the refrigerator, you may need to consider adding a maximum of 1/4" (70-1/4") to height of opening to allow additional clearance between cabinet doors and top of refrigerator trim when cabinet doors are in open position. For answers to your Monogram® or GE appliance questions, visit our website at geappliances.com or call GE Answer Center® service, 800.626.2000. Listed by Underwriters Laboratories Specification Revised 9/13 210320