GE WSLS1500HWW Use and Care Manual - Page 24

NOISE, POSSIBLE CAUSES, WHAT TO DO, Washer is noisy, Start/Pause, OTHER, Labels on the exterior,

Get GE WSLS1500HWW PDF manuals and user guides View all GE WSLS1500HWW manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Before you call for service... Troubleshooting Tips NOISE Washer is noisy POSSIBLE CAUSES Washer is uneven Washer load is unbalanced Washer is sitting too close to wall FDXVHVNQRFNLQJGXULQJF\FOH WHAT TO DO • Level the washer. See Leveling the Washer. • Press the Start/Pause button to stop the washer, open the lid and redistribute the load evenly. Close the lid and restart. • Pull washer away from the wall; about 4" is needed OTHER Labels on the exterior of the washer will not peel off cleanly POSSIBLE CAUSES WHAT TO DO Occasionally the adhesive used on the labels does not release cleanly • Use a hair dryer set at the lowest heat setting, directing the air at the label for a short amount of time. This will release the adhesive easily, without damaging the surface of the washer. 24

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
24
Before you call for service…
Troubleshooting Tips
NOISE
POSSIBLE CAUSES
WHAT TO DO
Washer is noisy
Washer is uneven
•
Level the washer. See Leveling the Washer.
Washer load is unbalanced
•
Press the
Start/Pause
button to stop the washer, open
the lid and redistribute the load evenly. Close the lid
and restart.
Washer is sitting too close to wall
•
Pull washer away from the wall; about 4” is needed
OTHER
POSSIBLE CAUSES
WHAT TO DO
Labels on the exterior
of the washer will not
peel off cleanly
Occasionally the adhesive used on
the labels does not release cleanly
•
Use a hair dryer set at the lowest heat setting, directing
the air at the label for a short amount of time. This will
release the adhesive easily, without damaging the
surface of the washer.