GE WSM2420DWW Quick Specs - Page 1

GE WSM2420DWW - Unitized Spacemaker Washer Manual

Page 1 highlights

GE Appliances WSM2420/80D - GE® 24" Unitized Spacemaker® Washer/Dryer Dimensions (in inches) 21-5/16 8 27-5/8 27-5/8 71-3/4 Distance from vent to back 4-1/2" 71-3/4 1-1/2 32-1/2 32-1/8 27-1/2 Drain 38 28-5/8 Water inletcold 27-1/4 23-7/8 27-1/4 23-7/8 Floor line 1" For leveling legs PowMeroCdoerdl WLoScaMtio2n420 Model WSM2700 Electrical Requirements: WSM2420D: Electric Dryer -This appliance should be connected to an individual, properly grounded branch ­circuit with 120/240V single-phase 60Hz electrical service and should be protected by 30-amp time-delay fuses or circuit ­breakers. This appliance is ­manufactured with the neutral connected to the frame. Power cord should be purchased separately. Note: These appliances are not approved for 120-volt operation. WSM2480D: Gas Dryer - This appliance should be connected to an individual, properly grounded branch circuit with a three-prong grounding-type receptacle and 120-volt single-phase 60 Hz electrical service and should be protected by 15- or20-amp time-delay fuses or ­circuit breakers. This appliance is equipped with a 6-foot long flexible U.L. listed 20-amp power cord to match a 15-amp receptacle. Gas Rated input 10,500 BTU/HR. Factory equipped for natural gas. Tested for LP gas. Dryers must be exhausted to the outside. Installation Information: For complete information, see installation instructions packed with the product. Power Cord Hole 9-1/2 WSM2420/2480S Power Cord Hole 12-1/2 41-1/2 41 Specification Revised 5/09 360327 Back View Back View Listed by Underwriters Laboratories For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at GEAppliances.com or call GE Answer Center® service, 800.626.2000.

  • 1
  • 2
  • 3

GE Appliances
WSM2420/80D – GE
®
24” Unitized Spacemaker
®
Washer/Dryer
Specification Revised 5/09
360327
Dimensions (in inches)
Floor line
Distance
from vent
to back 4-1/2"
28-5/8
Water
inlet-
cold
1" For leveling legs
32-1/8
27-1/4
23-7/8
27-5/8
71-3/4
32-1/2
23-7/8
27-5/8
27-1/4
38
71-3/4
1-1/2
21-5/16
8
Drain
27-1/2
Electrical Requirements:
WSM2420D:
Electric Dryer
–This appliance should be connected to an individual, properly
grounded branch circuit with 120/240V
single-phase 60Hz electrical service and should
be protected by 30-amp time-delay fuses or circuit breakers. This appliance is
manufactured with the neutral connected to the frame. Power cord should be
purchased separately.
Note:
These appliances are not approved for 120-volt operation.
WSM2480D:
Gas Dryer
This appliance should be connected to an individual, properly grounded
branch circuit with a three-prong grounding-type receptacle and 120-volt single-phase
60 Hz electrical service and should be protected by 15- or20-amp time-delay fuses or
circuit breakers. This appliance is equipped with a 6-foot long flexible U.L. listed
20-amp power cord to match a 15-amp receptacle.
Gas Rated
input 10,500 BTU/HR. Factory equipped for natural gas. Tested for LP gas.
Dryers
must
be exhausted to the outside.
Installation Information:
For complete information, see installation instructions packed with the product.
Power Cord Location
Back View
Power
Cord Hole
41-1/2
9-1/2
Listed by
Underwriters
Laboratories
For answers to your Monogram,
®
GE Profile
or
GE
®
appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center
®
service, 800.626.2000.