Gigabyte B365M H User Manual - Page 15

1 23 1 1 23 1 SS 1 S 1 23 1 23 1 7) F_ _S F_PANEL (Front Panel Header) Connect the power switch, reset switch, speaker, chassis intrusion switch/sensor and system status indicator on the chassis to this header according to the pin assignments below. Note the positive and negative pins before connecting the cables. Power LED Power Switch Speaker •• PLED/PWR_LED (Power LED): PLED+ PLED- PW+ PWSPEAK+ NC NC SPEAK- 2 20 1 19 HD+ HD- RESRES+ CICI+ PWR_LED+ PWR_LEDPWR_LED- Hard Drive Reset Activity LED Switch Power LED Chassis Intrusion Header System Status LED Connects to the power status indicator S0 On S3/S4/S5 Off on the chassis front panel. The LED is on when the system is operating. The LED is off when the system is in S3/S4 sleep state F_ •• PW (Power Switch): or powered off (S5). S S U 123 Connects to the power switch on the chassis front panel. You may configure the way to turn off your system using the power switch (refer to Chapter 2, "BIOS Setup," "Power," for more information). •• SPEAK (Speaker): Connects to the speaker on the chassis front panel. The system reports system startup status by issuing a beep code. One single short beep will be heard if no problem is detected at system startup. •• HD (Hard Drive Activity LED): Connects to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive is reading or writing data. •• RES (Reset Switch): Connects to the reset switch on the chassis front panel. Press the reset switch to restart the computer if the computer freezes and fails to perform a normal restart. •• CI (Chassis Intrusion Header): Connects to the chassis intrusion swit_ch/sensor on the chassis that can detect ifBthSe_ chassis cover has been removed. This function requires aB chassis with a chassis intrusion switch/senBsor. •• NC: No connection. The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this headSeBr,_make sure the wire assignments and the pin assignments are matched correctly. B U _ 8) F_AUDIO (Front Panel Audio Header) The front panel audio header supports High Definition audio (HD). You may connect your chassis front panel audio module to this header. Make_ sSure the wire assignments of the module connector match the pin assignments of the motherboard heaSd_er. Incorrect connection between the module connector and the motherboard header will make the device_unable to work or even damage it. B Pin No. Definition Pin No. Definition 1 MIC2_L 6 Sense 9 1 2 G_ NUD 7 FAUDIO_JD _ _10 3 2 3 M_ BIC2_R 8 No Pin F 4 NC 9 LINE2_L 5 LINE2_R 10 Sense Some chassis provide a front paFn_eUlSaBu3dFio module that has separated connectors on each wire instead of a single plug. For information about connecting the front panel audio module that has different wire assignments, please contact the chassis manufacturer. _0 _ _B _ - 15 - _F _