Gigabyte GA-870A-UD3 Manual - Page 97
Rebuilding in the operating system, All Programs, Start, Rebuild Raid, Rebuild, Finish
UPC - 818313010346
View all Gigabyte GA-870A-UD3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
• Rebuilding in the operating system Make sure the GIGABYTE SATA2/JMicron JMB362 SATA controller driver has been installed from the motherboard driver disk. Launch the GIGABYTE RAID CONFIGURER from All Programs in the Start menu. Step 1: In the GIGABYTE RAID CONFIGURER screen, right-click on the array to be rebuilt in the RAID LIST block. Select Rebuild Raid. (Or click the Rebuild icon in the tool bar.) Step 2: When the Rebuilding RAID Wizard appears, click Next. Step 3: Select a drive to rebuild the array and click Next. Step 4: Click Finish to start the RAID rebuilding process. Step 5: The rebuilding progress is displayed at the bottom of the screen. Step 6: When finished, restart your system. - 97 - Appendix
- 97 -
Appendix
•
Rebuilding in the operating system
Make sure the GIGABYTE SATA2/JMicron JMB362 SATA controller driver has been installed from the moth-
erboard driver disk. Launch the GIGABYTE RAID CONFIGURER from
All Programs
in the
Start
menu.
Step 1:
In the GIGABYTE RAID CONFIGURER screen,
right-click on the array to be rebuilt in the
RAID
LIST
block. Select
Rebuild Raid
. (Or click the
Rebuild
icon
in the tool bar.)
Step 3:
Select a drive to rebuild the array and click
Next
.
Step 2:
When the Rebuilding RAID Wizard appears,
click
Next
.
Step 4:
Click
Finish
to start the RAID rebuilding process.
Step 6:
When finished, restart your system.
Step 5:
The rebuilding progress is displayed at the
bottom of the screen.