Gigabyte GA-945PLM-S2 Manual - Page 22

Pwr_led, Battery

Get Gigabyte GA-945PLM-S2 PDF manuals and user guides View all Gigabyte GA-945PLM-S2 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

English 8) PWR_LED The PWR_LED connector is connected with the system power indicator to indicate whether the system is on/off. It will blink when the system enters suspend mode (S1). Pin No. Definition 1 MPD+ 1 2 MPD- 3 MPD- 9) BATTERY GA-945PLM-S2 Motherboard Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer's instructions. If you want to erase CMOS... 1. Turn off the computer and unplug the power cord. 2. Gently take out the battery and put it aside for about one minute. (Or you can use a metal object to connect the positive and negative pins in the battery holder to make them short for five seconds.) 3. Re-install the battery. 4. Plug the power cord in and turn on the computer. - 22 -

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
GA-945PLM-S2 Motherboard
- 22 -
English
8)
PWR_LED
The PWR_LED connector is connected with the system power indicator to indicate whether the
system is on/off. It will blink when the system enters suspend mode (S1).
Pin No.
Definition
1
MPD+
2
MPD-
3
MPD-
1
9)
BATTERY
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended
by the manufacturer.
Dispose of used batteries according to the manufacturer's
instructions.
If you want to erase CMOS...
1.
Turn off the computer and unplug the power cord.
2.
Gently take out the battery and put it aside for about one minute.
(Or you can use a
metal object to connect the positive and
negative pins in the battery holder to make them short for five
seconds.)
3.
Re-install the battery.
4.
Plug the power cord
in
and turn on the computer.