Gigabyte GA-990XA-UD3 R5 Manual - Page 11
x S/PDIF Out header, I/O Controller Chip
View all Gigabyte GA-990XA-UD3 R5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
USB Internal Connectors Back Panel Connectors I/O Controller Hardware Monitor South Bridge: - 14 x USB 2.0/1.1 ports (8 ports on the back panel, 6 ports available through the internal USB headers) VIA® VL805 chip: - 4 x USB 3.0/2.0 ports (2 ports on the back panel, 2 ports available through the internal USB header) * Be sure to connect your USB device(s) to the USB 2.0/1.1 ports before the USB 3.0 driver is installed. (Refer to the labels in section 1-7, "Back Panel Connectors.") 1 x 24-pin ATX main power connector 1 x 8-pin ATX 12V power connector 6 x SATA 6Gb/s connectors 1 x CPU fan header 2 x system fan headers 1 x power fan header 1 x front panel header 1 x front panel audio header 1 x S/PDIF Out header 1 x USB 3.0/2.0 header 3 x USB 2.0/1.1 headers 1 x serial port header 1 x Clear CMOS jumper 1 x Trusted Platform Module (TPM) header 1 x PS/2 keyboard/mouse port 1 x optical S/PDIF Out connector 2 x USB 3.0/2.0 ports 8 x USB 2.0/1.1 ports 1 x RJ-45 port 6 x audio jacks (Center/Subwoofer Speaker Out, Rear Speaker Out, Side Speaker Out, Line In, Line Out, Mic In) iTE® I/O Controller Chip System voltage detection CPU/System temperature detection CPU/System/Power fan speed detection CPU overheating warning CPU/System/Power fan fail warning CPU/System fan speed control * Whether the fan speed control function is supported will depend on the cooler you install. - 11 - Hardware Installation