Gigabyte GA-B85M-Gaming 3 User Manual - Page 13

3/4) CPU_FAN/SYS_FAN (Fan Headers) All fan headers on this motherboard are 4-pin. Most fan headers possess a foolproof insertion design. When connecting a fan cable, be sure to connect it in the correct orientation (the black connector wire is the ground wire). The speed control function requires the use of a fan with fan speed control design. For optimum heat dissipation, it is recommended that a system fan be installed inside the chassis. CPU_FAN: SYS_FAN: Pin No. Definition Pin No. Definition 1 1 GND 2 +12V 1 GND 1 2 Speed Control CPU_FAN 3 Sense SYS_FAN 3 Sense 4 Speed Control 4 VCC •• Be sure to connect fan cables to the fan headers to prevent your CPU and system from overheating. Overheating may result in damage to the CPU or the system may hang. •• These fan headers are not configuration jumper blocks. Do not place a jumper cap on the headers. 5) SATA3 0/1/2/3 (SATA 6Gb/s Connectors) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. 77 SATA3 32 10 Pin No. 1 2 3 4 Definition GND TXP TXN GND Pin No. 5 6 7 Definition RXN RXP GND 11 6) SATA2 4/5 (SATA 3Gb/s Connectors) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. 77 SATA2 54 11 Pin No. 1 2 3 4 Definition GND TXP TXN GND Pin No. 5 6 7 Definition RXN RXP GND To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Peripherals\SATA Configuration," for more information. - 13 -