Gigabyte GA-EP35-DS3 Manual - Page 96
GIGABYTE SATA2 controllers, Load Driver
View all Gigabyte GA-EP35-DS3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
GIGABYTE SATA2 controllers: Step 1: Restart your system to boot from the Windows Vista setup disk and perform standard OS installation steps. When a screen similar to that below appears (RAID/AHCI hard drive(s) will not be detected at this stage), select Load Driver. (Figure 12). Figure 12 Step 2: Specify the location where the driver is saved, such as your floppy disk (Figure 13). Figure 13 GA-EP35-DS3R/DS3 Motherboard - 96 -
GA-EP35-DS3R/DS3 Motherboard
- 96 -
GIGABYTE SATA2 controllers:
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation
steps. When a screen similar to that below appears (RAID/AHCI hard drive(s) will not be detected at this
stage), select
Load Driver
. (Figure 12).
Figure 12
Step 2:
Specify the location where the driver is saved, such as your floppy disk (Figure 13).
Figure 13