Gigabyte GA-F2A88X-D3HP User Manual - Page 25
SATA3 0/1/2/3/4/5/6/7 SATA 6Gb/s Connectors, CLR_CMOS Clear CMOS Jumper
![]() |
View all Gigabyte GA-F2A88X-D3HP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
DEBUG PORT DEBUG PORT DEBUG PORT DEBUG PORT DEBUG PORT DEBUG PORT 6) SATA3 0/1/2/3/4/5/6/7 (SATA 6Gb/s Connectors) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The AMD Chipset supports RAID 0, RAID 1, RAID 5, RAID 10, and JBOD. Refer to Chapter 3, "Configuring a RAID Set," for instructions on configuring a RAID array. G.QBOFM SATA3 6 7 7 1 7 1 1 1 SATA3 1 3 5 024 Pin No. Definition 1 GND 2 TXP 3 TXN 4 GND 7 5 RXN 7 6 RXP 7 GND To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Peripherals\SB SATA Configuration," for more information. 7) CLR_CMOS (Clear CMOS Jumper) Use this jumper to clear the BIOS configuration and reset the CMOS values to factory defaults. To clear the CMOS values, use a metal object like a screwdriver to touch the two pins for a few seconds. Open: Normal Short: Clear CMOS Values •• Always turn off your computer before clearing the CMOS values. •• After system restart, go to BIOS Setup to load factory defaults (select Load Optimized Defaults) or manually configure the BIOS settings (refer to Chapter 2, "BIOS Setup," for BIOS configurations). - 25 - Hardware Installation
![](/manual_guide/products/gigabyte-gaf2a88xd3hp-user-manual-1d4b147/25.png)