Gigabyte GA-F2A88X-HD3 User Manual - Page 15

_ B S B_ B _S S_ _ B SS U F_ 5) SATA3 0/1/2/3/4/5/6/7 (SATA 6Gb/s Connectors) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The AMD A88X Chipset supports RAID 0, RAID 1, RAID 5, RAID 10, and JBOD. Refer to Chapter 3, "Configuring SATA Hard Drive(s)," for instructions on configuring a RADEIDBUaGrray. DEBUG PORT 1 PORT 123 DEBUG PORT SATA3 7 DEBUG Pin No.DEBDUeGfinition PORT 1 PORGTND 2 TXP B S_ B 3 TXN 4 GND 5 RXN SATA3 6 5 6 RXP 7 GND DEBUG PORT 02 SATA3 1 3 4 1 7 1 7 7 •• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, the total number of hard drives must be an even number. •• A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does not have to be an even number.) •• A RAID 10 configuration requires four hard drives. DEBUG PORT DEBUG PORT 6) F_PANEL (Front Panel Header) Connect the power switch, reset switch, speaker, chassis intrusion switch/sensor and system status indicator on the chassis to this header according to the pin assignments below. Note the positive and negative pins before connecting the cables. Speaker Power Switch Power LED 20 19 •• PLED/PWR_LED (Power LED): SPEAK- PWR_LEDPWR_LED- Power LED System Status LED Connects to the power SPEAK+ PWPW+ PWR_LED+ CI+ CI- RES+ RES- Chassis Intrusion Header Reset Switch S0 On S3/S4/S5 Off status indicator on the chassis front panel. The LED is on when the system is operating. The LED is off when the PLEDPLED+ 21 HDHD+ Hard Drive Activity LED system is in S3/S4 sleep state or powered off (S5). •• PW (Power Switch): Connects to the power switch on the chassis front panel. You may configure the way to turn off your system B SS 1 _S S 1 23 using the power switch (refer to Chapter 2, "BIOS Setup," "Power Management," for more information). F_ •• SPEAK (Speaker): Connects to the speaker on the chassis front panel. The system reports system startup status by issuing a 1 23 1 1 23 1 beep code. One single short beep will be heard if no problem is detected at system startup. •• HD (Hard Drive Activity LED): 1 23 Connects to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive is 1 reading or writing data. •• RES (Reset Switch): Connects to the reset switch on the chassis front panel. Press the reset switch to restart the computer if the computer freezes and fails to perform a normal restart. •• CI (Chassis Intrusion Header): Connects to the chassis intrusion switch/sensor on the chassis that can detect if the chassis cover has been removed. This function requires a chassis with a chassis intrusion switch/sensor. B_ S The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assignments are matched correctly. - 15 - F_ U