Gigabyte GA-G41MT-S2 Manual - Page 14
CPU_FAN/SYS_FAN Fan Headers, SATA2_0/1/2/3 SATA 3Gb/s Connectors - cpu support
View all Gigabyte GA-G41MT-S2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
3/4) CPU_FAN/SYS_FAN (Fan Headers) The motherboard has a 4-pin CPU fan header (CPU_FAN) and a 3-pin (SYS_FAN) system fan header. Most fan headers possess a foolproof insertion design. When connecting a fan cable, be sure to connect it in the correct orientation (the black connector wire is the ground wire). The motherboard supports CPU fan speed control, which requires the use of a CPU fan with fan speed control design. For optimum heat dissipation, it is recommended that a system fan be installed inside the chassis. 1 CPU_FAN CPU_FAN: Pin No. Definition 1 GND 2 +12V 3 Sense 4 Speed Control 1 SYS_FAN SYS_FAN: Pin No. Definition 1 GND 2 +12V 3 Sense DEBUG PORT DEBUG PORT • Be sure to connect fan cables to the fan headers to prevent your CPU and system from over- heating. Overheating may result in damage to the CPU or the system may hang. DEBUG PORT • These fan headers are not configuration jumper blocks. Do not place a jumper cap on the headers. DEBUG PORT 5) SATA2_0/1/2/3 (SATA 3Gb/s Connectors) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. SATA2_3 7 SATA2_2 7 SATA2_1 7 7 1 SATA2_0 Pin No. Definition 1 GND 1 2 TXP 3 TXN 1 4 GND 5 RXN 1 6 RXP 7 GND Hardware Installation - 14 - Please connect the L-shaped end of the SATA cable to your SATA hard drive.