Gigabyte GA-H110M-D3H R2 User Manual - Page 14

B SS 1 S 1 23 1 23 1 1 23 1 1 23 1 5) SATA3 0/1/2/3 (SATA 6Gb/s Connectors) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. 11 SATA3 10 32 77 Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND DEBUG PORT DEBUG PORT To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Peripherals\SATA And RST Configuration," for more information. DEBUG PORT DEBUG PORT 6) F_PANEL (Front Panel Header) Connect the power switch, reset switch, speaker, and system status indicator on the chassis to this header according to the pin assignments below. Note the positive and negative pins before connecting the cables. Power LED Power Switch Speaker • PLED/PWR_LED (Power LED): System Status LED S0 On S3/S4/S5 Off Connects to the power status indicator on the chassis front panel. The LED is on when the system is operating. The LED is off when the system is in S3/S4 sleep state PLED+ PLED-PW+ PWSPEAK+ NC NC SPEAK- F_ 2 1 20 19 or powered off (S5). • PWF_(Power Switch): SS 123 U Connects to the power switch on the chassis front panel. You may HD+ HD- RESRES+ CICI+ PWR_LED+ PWR_LEDPWR_LED- configure the way to turn off your system using the power switch (refer to Chapter 2, "BIOS Setup," "Power," for more information). • SPEAK (Speaker): Hard Drive Reset Activity LED Switch Power LED Chassis Intrusion Header Connects to the speaker on the chassis front panel. The system reports system startup status by issuing a beep code. One single short beep will be heard if no problem is detected at system startup. •• HD (Hard Drive Activity LED): Connects to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive is reading or writing data. •• RES (Reset Switch): Connects to the reset switch on the chassis front panel. Press the reset switch to restart the computer if the _S computer freezes and fails to perform a normal restart. • CI (Chassis Intrusion Header): Connects removed. Ttohtishefucnhcatisosnisreinqtruuirseiosnascwhiatcshs/issewnist_hoBraocnhtahsescishainstsruisstiohnatscwaintcdhe/steecntsiof rt.he chaBssSis_ B cover has been •• NC: No Connection. The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, spSeaBk_er and etc. When connecting your chassis front panel module to this header, make sure the wire assignments aBnd the pin assignments are matched correctly. - 14 - _S S_ _ B