Gigabyte GA-H67A-D3H-B3 Manual - Page 24
SATA3_0/1 SATA 6Gb/s Connectors, Controlled by Intel H67 Chipset - raid
View all Gigabyte GA-H67A-D3H-B3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
7) SATA3_0/1 (SATA 6Gb/s Connectors, Controlled by Intel H67 Chipset) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The SATA3_0 and SATA3_1 connectors support RAID 0 and RAID 1. RAID 5 and RAID 10 can be implemented on the two connectors with the SATA2_2/3/4/5 connector . (Note) Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. SATA3_0 7 1 7 1 SATA3_1 Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND 8) SATA2_2/3/4/5 (SATA 3Gb/s Connectors, Controlled by Inel H67 Chipset) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. DEBUG PORT DEBUG PORT Each SATA connector supports a single SATA device. The Intel H67 chipset supports RAID 0, RAID 1, RAID5, and RAID 10. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configur- ing a RAID array. SATA2_4 7 7 SATA2_5 SATA2_2 1 1 SATA2_3 Pin No. 1 2 3 4 5 Definition GND TXP TXN GND RXN 6 RXP 7 GND DEBUG PORT DEBUG PORT DEBUG PORT DEBUG PORT Please connect the L-shaped end of the SATA cable to your SATA hard drive. •• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, the total number of hard drives must be an even number. •• A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does not have to be an even number.) •• A RAID 10 configuration requires four hard drives. (Note) When a RAID set is built across the SATA 6Gb/s and SATA 3Gb/s channels, the system performance of the RAID set may vary depending on the devices being connected. Hardware Installation - 24 -