Gigabyte GA-M68M-S2 Manual - Page 72
B. Installing Windows Vista
View all Gigabyte GA-M68M-S2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
B. Installing Windows Vista (The procedure below assumes that only one RAID array exists in your system.) Step 1: Restart your system to boot from the Windows Vista setup disk and perform standard OS installation steps. When a screen similar to that below appears (RAID hard drive will not be detected at this stage), select Load Driver (Figure 3). Figure 3 Step 2: Insert the motherboard driver disk into your system and browse to the following directory(for Windows Vista 32-bit): \BootDrv\UDA\WinVista\sataraid For Windows Vista 64-bit, browse to the following directory: \BootDrv\UDA\WinVista64\sataraid Appendix Figure 4 - 72 -
Appendix
- 72 -
B. Installing Windows Vista
(The procedure below assumes that only one RAID array exists in your system.)
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation
steps. When a screen similar to that below appears (RAID hard drive will not be detected at this stage),
select
Load Driver
(Figure 3).
Step 2:
Insert the motherboard driver disk into your system and browse to the following directory(for Windows
Vista 32-bit):
\BootDrv\UDA\WinVista\sataraid
For Windows Vista 64-bit, browse to the following directory:
\BootDrv\UDA\WinVista64\sataraid
Figure 3
Figure 4