Gigabyte GA-MA790FXT-UD5P Manual - Page 50

Note: In case you need to set this item to AHCI mode and want to install Windows XP onto the AHCI hard drive, you have to install the SATA controller driver during the OS installation. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for how to make a driver diskette and install the driver. Smart Backup CMOS Setup Utility-Copyright (C) 1984-2009 Award Software Smart Backup  Controller 0 (GSATA2 0/1)  Controller 1 (GSATA2 2/3) [Press Enter] [Press Enter] Item Help Menu Level Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults The Controller 0 (GSATA2 0/1)/Controller 1 (GSATA2 2/3) submenu allows you to check the information of the hard drive(s) connected to the GSATA2_0~3 connectors or to configure a RAID array. The Controller 0 (GSATA2 0/1) supports the GSATA2_0 and GSATA2_1 connectors and the Controller 1 (GSATA2 2/3) supports the GSATA2_2 and GSATA2_3 connectors. After the configuration, ensure the SATA controller driver has been installed in the operating system. You can install the Smart Backup utility (refer to Chapter 5, "Configuring SATA Hard Drive(s)," to view the device status in the operating system. Controller 0 (GSATA2 0/1)/ Controller 1 (GSATA2 2/3) CMOS Setup Utility-Copyright (C) 1984-2009 Award Software Controller 0 (GSATA2 0/1)  Disk/RAID Status  Smart Backup Config [Press Enter] [Press Enter] Item Help Menu Level Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults GA-MA790FXT-UD5P Motherboard - 50 -