Gigabyte GA-X79-UD7 User Manual - Page 27
SATA3 0/1 SATA 6Gb/s Connectors, Controlled by Intel X79 Chipset, SATA2 2/3/4/5 SATA 3Gb/s
View all Gigabyte GA-X79-UD7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
6) SATA3 0/1 (SATA 6Gb/s Connectors, Controlled by Intel X79 Chipset) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The "SATA3 0" and "SATA3 1" connectors support RAID 0 and RAID 1. RAID 5 and RAID 10 can be implemented on the two connectors with the "SATA2 2/3/4/5" connector . (Note) Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. G.QBOFM SATA3 7 7 11 10 Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND 7) SATA2 2/3/4/5 (SATA 3Gb/s Connectors, Controlled by Intel X79 Chipset) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel X79 Chipset supports RAID 0, RAID 1, UG RAID 5, and RAID 10. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring T a RAID array. G.QBOFM G.QBOFPMin No. Definition 1 GND SATA2 2 TXP 7 1 53 3 TXN 4 GND 7 1 42 5 RXN 6 RXP 7 GND DEBUG PORT (Note) Please connect the L-shaped end of the SATA cable to your SATA hard drive. •• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, the total number of hard drives must be an even number. •• A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does not have to be an even number.) •• A RAID 10 configuration requires four hard drives. When a RAID set is built across the SATA 6Gb/s and SATA 3Gb/s channels, the system performance of the RAID set may vary depending on the devices being connected. - 27 - Hardware Installation