Gigabyte GA-Z270-Gaming K3 RAID Setup Guide - Page 17
B. Rebuilding an Array, Performing the Rebuild in the Operating System, Manage, Rebuild
View all Gigabyte GA-Z270-Gaming K3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
B. Rebuilding an Array Rebuilding is the process of restoring data to a hard drive from other drives in the array. Rebuilding applies only to fault-tolerant arrays such as RAID 1, RAID 5 or RAID 10 arrays. The procedures below assume a new drive is added to replace a failed drive to rebuild a RAID 1 array. (Note: The new drive must have equal or greater capacity than the old one.) Turn off your computer and replace the failed hard drive with a new one. Restart your computer. •• Performing the Rebuild in the Operating System While in the operating system, make sure the chipset driver has been installed from the motherboard driver disk. Then launch the Intel® Rapid Storage Technology utility from the Start menu. Step 1: Go to the Manage menu and click Rebuild to another disk in Manage Volume. Step 2: Select a new drive to rebuild the RAID and click Rebuild. The Status item on the left of the screen displays the rebuild progress. After the RAID 1 volume rebuilding, the Status will display as Normal. - 17 -