Gigabyte GA-Z97X-UD5H User Manual - Page 28
GSATA3 6/7 SATA 6Gb/s Connectors, Controlled by Marvell, 88SE9172 Chips, Z97 Chipset
![]() |
View all Gigabyte GA-Z97X-UD5H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
B_ 8) SATA3 0/1/2/3/4/5 (SATA 6Gb/s ConnectorSs, C_ ontrolled by Intel® Z97 Chipset) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel® Chipset supports RAID 0, RAID 1, RAID 5, and RAID 10. Refer to Chapter 3, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. SATA3 1 0 7 7 G.QBOFM SATA3 3 2 54 Pin No. Definition 1 GND 1 2 TXP 3 TXN 1 4 GND 5 RXN S_ 6 RXP 7 GND 9) GSATA3 6/7 (SATA 6Gb/s Connectors, Controlled by Marvell® 88SE9172 Chips) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The Marvell® chip supports RAID 0 and RAID 1. Refer to Chapter 3, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. GSATA3 7 6 7 7 G.QBOFM 1 1 Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND •• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, the total number of hard drives must be an even number. •• A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does not have to be an even number.) •• A RAID 10 configuration requires four hard drives. •• To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Peripherals\SATA Configuration," for more information. UG T •• M.2, SATA Express, and SATA3 4/5 connectors can only be used one at a time. The SATA3 4/5 connectors will become unavailable when an M.2 SSD is installed. Hardware Installation - 28 -
![](/manual_guide/products/gigabyte-gaz97xud5h-user-manual-2f0dae2/28.png)