Gigabyte H410M K User Manual - Page 18

DEBUG PORT DEBUG PORT S_ 6) SATA3 2/3 (SATA 6Gb/s Connectors) The SATA connectors conform to S_ATFA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. This motherboard supports RAID 0, RAID 1, and RAID 5. Please navigate to the "Configuring a RAID Set" page of GIGABYTE's website for instructions on configuring a RAID array. _0 F 7 1 7 SATA3 32 1 Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND To enable hot-plugging for the SATA ports, please visit the "BIOS Setup," "Settings\IO Ports\SATA And RST Configuration," webpage of GIGABYTE's website for more information. _3 U 7) M2A_SB (M.2 Socket 3 Connector) The M.2 connectors support M.2 SATA SSDs or M.2 PCIe SSDs and support RAID configuration. Please note that an M.2 PCIe SSD cannot be used to create a RAID set with a SATA hard drive. Please navigate to the "Configuring a RAID Set" page of GIGABYTE's website for instructions on configuring a RAID array. 110 80 60 42 Follow the steps below to correctly install an M.2 SSD in the M.2 connector. Step 1: Pull the clip's tab up and out of the mounting hole. Slide the M.2 SSD into the connector at an angle. Step 2: Press the M.2 SSD down and then secure it by pressing the clip's tab into the mounting hole. - 18 -