Gigabyte MD30-RS0 Manual - Page 32
SATA_DOM0 SATA port 0 Jumper, ME_UPDATE ME Update Jumper
View all Gigabyte MD30-RS0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
1) SATA_DOM0 (SATA port 0 Jumper) CAUTION! • If the SATA DOM power is supplied by the motherboard, set the jumper to pin 1-2. • If the SATA DOM power is supplied by external power, set the jumper to pin 2-3. • If a SATA type hard drive is connected to the motherboard, please ensure the jumper is closed and set to 2-3 pins (Default setting), in order to reduce any risk of hard disk damage. Please refer to the pin definition table in the following. Pin No. Definition 1 1 P5V 2 SATA0 Pin7 3 GND 2) ME_UPDATE (ME Update Jumper) 1 1-2 Close: Normal operation (Default setting) 1 2-3 Close: ME recovery mode. - 32 - Hardware Installation
- 32 -
Hardware Installation
1)
SATA_DOM0 (SATA port 0 Jumper)
CAUTION!
•
If the SATA DOM power is supplied by the motherboard, set the jumper to pin 1-2.
•
If the SATA DOM power is supplied by external power, set the jumper to pin 2-3.
•
If a SATA type hard drive is connected to the motherboard, please ensure the jumper is closed
and set to
2-3 pins
(Default setting), in order to reduce any risk of hard disk damage.
Please refer to the pin definition table in the following.
Pin No.
Definition
1
P5V
2
SATA0 Pin7
3
GND
1
2)
ME_UPDATE (ME Update Jumper)
1-2 Close: Normal operation (Default setting)
2-3 Close: ME recovery mode.
1
1