Graco 8A15NCT Owners Manual - Page 37
Using LATCH to install Base
UPC - 047406094516
View all Graco 8A15NCT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
7.3 Using LATCH to install Base 1. For ease of installation, extend LATCH to its maximum length and remove from storage bars. 2. Position base in vehicle seat as shown. 3. Make sure LATCH is through vehicle/LATCH belt path normally used for vehicle seat belt. . Belt must lay flat and not be twisted. 4. Hook Connectors to vehicle lower anchors. Pull firmly on Connectors to be sure they are attached . 5. Tighten LATCH by pushing down hard on base and pulling the adjustment belt . 6. NEVER put two LATCH connectors on one vehicle LATCH anchor unless specifically allowed by the vehicle manufacturer . 7. Test infant restraint for secure installation as described in infant restraint "Final Safety Check" page.40. 8. Check that the LATCH stays tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Graco at 1-800-345-4109. 37